Samsung SRF836WDRS Manual Do Utilizador

English - 18

When moving your refrigerator 

To prevent floor damage, be sure the front 
adjusting legs are in the up position (above 
the floor). 
Refer to ‘Adjusting the Level’ on page 
23.

Flat-blade screw 
driver (-)

Control Lever

Flooring

For proper installation, you must place this 
refrigerator on a level, hard surface that is the 
same height as the rest of the floor. 
This surface should be strong enough to support a 
fully loaded refrigerator. 
To protect the finish of the flooring, cut a large 
section of the cardboard carton and place it under 
the refrigerator where you are working. 
When moving the refrigerator, you need to pull and 
push it straight forwards or back. 
Do not wiggle it from side to side.

REMOVING THE REFRIGERATOR 
DOORS

For some installations, you need to remove the 
fridge and freezer drawers so you can move the 
refrigerator to its final location. 

need to. 
If you do not need to remove the refrigerator doors 
or drawers, go to ‘Leveling the Refrigerator’ on 
page 23. If you need to remove the doors and 
drawers. continue below. 
Before removing the doors or drawers, make sure 
you read the following warnings:

Disconnect power to the refrigerator 
before removing the door or drawer.

•  Be careful not to drop, damage 

or scratch the door / drawer while 
removing them.

•  Be careful not to injure yourself while removing 

the doors/drawer.

•  Reattach the door/drawer properly to avoid: 

 

- Moisture from air leakage.

 

- Uneven door alignment.

 

- Wasting energy due to improper door seal.

Disassembling the refrigerator doors

Be careful not to drop and scratch the 
doors while removing them.

DA68-03055B (EN)-02-���.indd   18

15. 5. 7.   �� 2:51