Samsung On5 Pre-paid Documentação legal
Health and Safety Information 2
Section 1: Health and Safety Information
This section outlines the safety precautions
associated with using your phone. The terms
“mobile device” or “cell phone” are used in this
section to refer to your phone. Read this
information before using your mobile device.
associated with using your phone. The terms
“mobile device” or “cell phone” are used in this
section to refer to your phone. Read this
information before using your mobile device.
Specific Absorption Rate (SAR)
Certification Information
Your wireless device is a radio transmitter and
receiver. It is designed and manufactured not to
exceed the exposure limits for Radio Frequency
(RF) energy set by the Federal Communications
Commission (FCC) of the U.S. Government.
receiver. It is designed and manufactured not to
exceed the exposure limits for Radio Frequency
(RF) energy set by the Federal Communications
Commission (FCC) of the U.S. Government.
These FCC RF exposure limits are derived from
the recommendations of two expert
organizations: the National Council on Radiation
Protection and Measurement (NCRP) and the
Institute of Electrical and Electronics Engineers
(IEEE). In both cases, the recommendations were
developed by scientific and engineering experts
drawn from industry, government, and academia
after extensive reviews of the scientific literature
related to the biological effects of RF energy.
the recommendations of two expert
organizations: the National Council on Radiation
Protection and Measurement (NCRP) and the
Institute of Electrical and Electronics Engineers
(IEEE). In both cases, the recommendations were
developed by scientific and engineering experts
drawn from industry, government, and academia
after extensive reviews of the scientific literature
related to the biological effects of RF energy.
The RF exposure limit set by the FCC for wireless
mobile devices employs a unit of measurement
known as the Specific Absorption Rate (SAR).
The SAR is a measure of the rate of absorption of
RF energy by the human body expressed in units
mobile devices employs a unit of measurement
known as the Specific Absorption Rate (SAR).
The SAR is a measure of the rate of absorption of
RF energy by the human body expressed in units
of watts per kilogram (W/kg). The FCC requires
wireless devices to comply with a safety limit of
1.6 watts per kilogram (1.6 W/kg).
wireless devices to comply with a safety limit of
1.6 watts per kilogram (1.6 W/kg).
The FCC SAR limit incorporates a substantial
margin of safety to give additional protection to
the public and to account for any variations in
measurements.
margin of safety to give additional protection to
the public and to account for any variations in
measurements.
SAR tests are conducted using standard
operating positions accepted by the FCC with the
device transmitting at its highest certified power
level in all tested frequency bands. Although the
SAR is determined at the highest certified power
level, the actual SAR level of the device while
operating can be well below the maximum
reported value. This is because the device is
designed to operate at multiple power levels so
as to use only the power required to reach the
network. In general, the closer you are to a
wireless base station antenna, the lower the
power output of the device.
operating positions accepted by the FCC with the
device transmitting at its highest certified power
level in all tested frequency bands. Although the
SAR is determined at the highest certified power
level, the actual SAR level of the device while
operating can be well below the maximum
reported value. This is because the device is
designed to operate at multiple power levels so
as to use only the power required to reach the
network. In general, the closer you are to a
wireless base station antenna, the lower the
power output of the device.
Before a new model device is available for sale
to the public, it must be tested and certified to
the FCC that it does not exceed the SAR limit
established by the FCC. Tests for each model
phone are performed in positions and locations
(e.g. at the ear and worn on the body) as
required by the FCC. For body-worn operation,
this device has been tested and meets FCC RF
to the public, it must be tested and certified to
the FCC that it does not exceed the SAR limit
established by the FCC. Tests for each model
phone are performed in positions and locations
(e.g. at the ear and worn on the body) as
required by the FCC. For body-worn operation,
this device has been tested and meets FCC RF