Zebra 01407-000 Manual Do Utilizador
33
Programming
Software Command Syntax
03/03/2009
TTP 1020™/TTP 1030™ Technical Manual
P1003643-001
At completed printout, an ESC Z command effects paper feed until a black mark is detected,
that is, when black-to-white transition is detected at the trailing edge of the black mark. The
paper feed then continues the number of steps specified by n1n2, at which point the correct
cut-position is assumed.
that is, when black-to-white transition is detected at the trailing edge of the black mark. The
paper feed then continues the number of steps specified by n1n2, at which point the correct
cut-position is assumed.
In black mark mode, an ESC Z
starts looking for a black mark at the current position and
continues for one page length. If no black mark is found, bit 3 in status byte 1 is set to 1 and
the printer will report NAK 0A on the next status query.
the printer will report NAK 0A on the next status query.
When black mark mode is disabled, ESC Z will perform a form feed without cut (disregarding
the setting of parameter 34).
the setting of parameter 34).
Text Commands
Text received by the TTP 10X0 is printed with the currently selected font and font attributes.
Text exceeding the page width is wrapped with the line spacing selected.
Text will be printed when both a linefeed and a print command have been received.
ESC x
n1 n2
Delay cut after black mark detection
1B
78
n1
n2 hex
027
120 n1
n2 decimal
n1n2 Sets the number of 0.125-mm steps to feed between the black mark detection and
the cut. n1 is the higher-order and n2 the lower-order byte.
ESC Z
Go to next black mark
1B
5A hex
027
090 decimal