Samsung WFF500 Pyykinpesukone, 9 kg Manual Do Utilizador

STEP 5 - Powering your washing machine

Plug the power cord into a wall socket, an AC 220 - 240 V / 50 Hz approved electrical outlet protected by a fuse or 
circuit breaker. (For more information on the electrical and grounding requirements, refer to the “Electrical supply 

and grounding” section on page 12.)

Test run
Make sure that you install your washing machine correctly by running the Rinse+Spin 

 cycle after 

the installation is complete.

STEP 6 - Running Calibration Mode

Your Samsung washing machine detects the weight of the laundry automatically. For a more accurate weight 
detection, it is recommended running Calibration Mode immediately after installing the washing machine. Follow 
the steps below to run Calibration Mode.

Before running Calibration Mode, make sure that there is nothing in the drum or on top of the washing 
machine.

1.  Turn the washing machine off.
2.  Press the Power   button while holding down the Temp.   and Delay End   buttons simultaneously. The 

washing machine will turn on and "CLB" will appear on the display.

3.  Press the Start/Pause   button to start Calibration Mode.
4.  The drum will rotate clockwise and counter-clockwise for about 3 minutes.
5.  When Calibration Mode is complete, "End" (or “0”) appears on the display and the washing machine will turn 

off automatically.

6.  The washing machine is now ready for use.

WF90F5_03367H-00_EN.indd   18

2015-07-17     7:56:08