Samsung HW-H7501 Manual Do Utilizador

24

25

AUX IN

OPTICAL IN

HDMI IN

HDMI OUT (TV)

Samsung may offer updates for the Soundbar's system 

firmware in the future.
If an update is offered, you can update the firmware by 

connecting a USB device with the firmware update 

stored on it to the USB port on your Soundbar.
Note that if there are multiple update files, you must load 

them onto the USB device singly and use them to 

update the firmware one file at a time.
Please visit samsung.com or contact the Samsung call 

centre to receive more information about downloading 

updates files.

 

●

I nsert a USB device containing the firmware 

update into the USB port on the main unit.

●

Updating firmware may not work properly if 

audio files supported by the Soundbar are 

stored in the USB storage device.

●

Do not disconnect the power or remove the 

USB device while updates are being applied. 

The main unit will turn off automatically after 

completing the firmware update.

●

After the update, all settings are reset to their 

factory default settings. We recommend you 

write down your settings so that you can 

easily reset them after the update. Note that 

updating firmware resets the subwoofer 

connection too. If connection to the 

subwoofer is not re-established automatically 

after the update, refer to page 15. 

If the firmware fails to update, we recommend 

formatting the USB device in FAT16 and 

trying again.

●

Once the software update is completed, turn 

off the product and then press and hold the  

( p ) button on the remote control for more 

than 5 seconds. “INIT” appears on the 

display and the unit is powered off. The 

updgrade is complete.

●

Do not format the USB device in the NTFS 

format. The Soundbar does not support the 

NTFS file system.

●

Depending on the manufacturer, some USB 

devices may not be supported.

If you have connected the main unit to a TV with a 

digital optical cable, set the Auto Power function ON 

to have the Soundbar turn on automatically when you 

turn the TV on.

AUTO POWER LINK

Display

ON

OFF

Connect the Soundbar and an External Device with 

an Optical cable.

Press the 

 (Function) button on the main unit’s 

top panel or the SOURCE button on the remote 

control to select the D.IN mode.

Press the Anynet+ button on the remote control 

to toggle the Auto Power Link function on and off.

 

●

Depending on the connected device, Auto 

Power Link may not function.