Samsung RF30HMEDBSL Manual Do Utilizador

English - 18

When moving your refrigerator 

To prevent floor damage, be sure the front 

adjusting legs are in the up position (above 

the floor).  

Refer to ‘Adjusting the doors’ on page 

22.

Flat-blade screw 

driver(-)

Control Lever

FLOORINg

For proper installation, you must place this 

refrigerator on a level, hard surface that is the 

same height as the rest of the floor. This surface 

should be strong enough to support a fully loaded 

refrigerator. To protect the finish of the flooring, cut 

a large section of the cardboard carton and place 

it under the refrigerator where you are working. 

When moving a refrigerator, you need to pull and 

push it straight forwards or back. Do not wiggle it 

from side to side.

REMOVINg THE 

REFRIgERATOR DOORS

For some installations, you need to remove the 

fridge doors and freezer drawer so you can move 

the refrigerator to its final location. Do not remove 

the doors/drawers if you don’t need to. If you 

do not need to remove the refrigerator doors or 

drawers, go to ‘Adjusting the Level’ on page 22. 

If you need to remove the doors and drawers. 

continue below. Before removing the doors 

or drawers, make sure you read the following 

warnings:

Disconnect power to the refrigerator before 

removing the door or drawer.

•  Be careful not to drop, damage, or

scratch the doors/drawer while removing
them.

•  Be careful not to injure yourself while removing 

the doors/drawer.

•  Reattach the doors/drawer properly to avoid:

-  Moisture from air leakage.

-  Uneven door alignment.

-  Wasting energy due to improper door seal.

DA68-02952D-02.indb   18

2016. 12. 16.   �� 7:50