Samsung תנור טורבו כפול זכוכית שחורה, 65 ליטר Manual Do Utilizador

installation

This oven may be installed only by an approved electrician. The installer is responsible for 

connecting the appliance to the main supply, while observing the relevant safety regulations.

•  Ensure protection from live parts when installing the oven.

Power connection

If the appliance is not connected to the mains with a plug, a multi-

pole isolator switch (with at least 3 mm contact spacing) must be 

provided in order to satisfy safety regulations. The power cable 

(H05 RR-F or H05 VV-F, min., 2.5 mm²) must be of sufficient 

length to be connected to the oven, even if the oven stands on 

the floor in front of its built-in cabinet. Open the rear connection 

cover of the oven with a screwdriver and loosen the screws of the 

cable clamp before you connect the power lines to the relevant 

connection terminals. The oven is earthed via the (   )-terminal. 

The yellow and green cable(earth connection) must be connected first 

and be longer than the others. If the oven is connected to the mains with a plug, this plug must remain 

accessible after the oven is installed. Samsung will take no responsibility for accidents that originate from a 

missing or faulty earth connection.

WARNING: Do not allow the connecting cable to become trapped during installation, and 

prevent it coming into contact with hot parts of the oven.

nstallation in the cabinet

With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside of 

the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage of plastic 

surfaces or adhesive from the heat.
There should be a ventilation gap in the base of the kitchen cabinet where the oven is to be placed.  

For ventilation, a gap of about 50 mm should be left between the lower shelf and the supporting wall.  

If the oven is to be installed below a hob, the hob’s installation instructions should be followed.

595

370

560

545

21

595

Max.50

Min.550

Min.560

Min.50

Min.590 ~ Max.600

Min.460 x Min.50

572 550

 

595

370

560

545

21

115

595

175

Max. 

464

Min.550

Min.560

Min.600

Min.460 x Min.50

572 550

Max. 476

Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws.  

Make sure that a gap of at least 5 mm should be left between the appliance and the adjacent cabinet. 
After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside 

of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and 

release the 2 screws on the both sides of the oven.

WARNING: The built-in furniture must have a minimum ventilation gap for Air-flow as shown 

on picture. Do not cover this hole with strips of wood, for this is used to provide ventilation.

The front exterior of the oven such as handle is different model by model. But the size of the 

oven in the picture is same.

  INS
TALLA

TION

BROWN or 

BLACK

BLUE or 

WHITE

YELLOW and 

GREEN

BF1C4B223_ML_DG68-00670A-00_EN.indd   9

2015-03-26     5:00:22