acousti pack pre-cut kit for antec slk 3700 bqe Manual Do Utilizador

Pack Contents: 
The AcoustiPack™ AP AntecBQE contains 
16 pieces, of 2 different acoustic materials 
and an optional washable air filter. 

ONLY position the materials as directed in the fitting directions and as depicted in the graphics above.
DO NOT cover any necessary ventilation holes in the case with materials.
DO NOT position the rear of the case close to a permanent heat source, such as a radiator, or very close to an airflow obstruction, 
such as a wall. This may inhibit air circulation required for cooling. Leave a gap at the rear of the case of at least 20cm to allow 
free movement of air in and out of the case.
DO NOT position materials inside the case in such a way that may inhibit the correct functioning of any internal components, 
especially cooling fans, disc drives and moving parts. These components require adequate space and ventilation. Whilst every care 
has been taken to produce a set of materials that will be appropriate for the majority of component configurations, it is the 
responsibility of the machine builder to position materials appropriately to facilitate normal functioning of internal components.

Fitting Directions:  
Fit according to the positions indicated, in the numerical order shown 
from    to    . Where self adhesive is on the reverse of the materials, 
remove the backing sheet and adhere lightly to clean and dust-free 
surfaces, making sure that the material is correctly positioned. If you 
make a mistake - it can be re-applied for a second attempt - but be 
aware that excessive re-application will cause a deterioration in the 
adhesive. Once well positioned, press the materials firmly into place.

Ensure you read the important safety information before 
installing the materials.  

v 1.0

PRINTED ON PAPER FROM SUSTAINABLE SOURCES. PLEASE RECYCLE ME AFTER USE!

GAP 18mm

GAP 18mm

      Do not use the air filter if 
maximum airflow is required for 
cooling purposes.
If the air filter is used: Remove 
and wash regularly to maintain 
an adequate airflow.

   

3½-inch drive bay mounting is 
shown removed for clarity.  
Removal may not be required 
for fitting part     .

Position parts      to     onto the back of drive bay covers in unused drive bays.
To gain access, carefully remove front cover by pressing tabs marked            
and lift the cover off.

= Optional

      Position part      to 
allow adequate airflow 
around any hard-disks.

1. Remove the uppermost 5¼-inch 
drive bay cover to help with access, 
and turn the case upside down.
2. Peel back only a portion of the self-
adhesive backing sheet and fit the     
front section of this part first. 
Once in position, fit the remainder of 
the part.

Part      goes on the 
inside of the front-
panel hinge door.