Acumen sp500 Manual Do Utilizador
Electrical Connections
Speedometer
Wire
Colour
Purpose
Red/Black
Ignition – a circuit which has 12V when the ignition is switched on AND
also connect to the Red wire of the Speedo reader
Red
12V – permanent power supply
Black/Green
LED Indicator number 2 – switches to ground/earth/0V
White
LED Indicator number 3 – switches to 12V
Black
Ground/earth
AND
also connect to the Green wire of the Speedo reader
Blue
LED Indicator number 5 – switches to 12V
Yellow
Speedometer signal – connect to the BLUE wire of the Speedo head reader
Blue/Black
LED Indicator number 4 – switches to ground/earth/0V
Green
LED Indicator number 1 – switches to 12V
NOTE! If you are using one 12V switched for both the left and right m/c indicator lights you will need to
fit two diodes in the circuit thus;
Diodes are available from Acumen Electronics
Free of Charge on Request – or from any
Electronics stockist.
fit two diodes in the circuit thus;
Diodes are available from Acumen Electronics
Free of Charge on Request – or from any
Electronics stockist.
M/c Ind Light
M/c Ind Light
Speedo
Using it
Knowing the controls
INC button
MOD Button
As the name suggests;
The MODE Button –
It increases values of the Trip
This changes from ODO to TRIP to CLOCK
and also sets the speedometer ratio
and also sets the speedometer ratio
or Clock or Speedo ratio
DEC button
As the name
suggests;
suggests;
It decreases
values of the
Trip or Clock or
Speedo ratio
values of the
Trip or Clock or
Speedo ratio
UNIT button
As the name suggests;
It changes the Speedo,
trip and ODO from
trip and ODO from
Miles to Kilometers and
vice/versa
vice/versa
Page 4