Alcatel-Lucent omniswitch 8800-7700-7800 Guia Do Utilizador
Quick Steps for Applying Configuration Files
Working With Configuration Files
page 6-4
OmniSwitch 7700/7800/8800 Switch Management Guide
April 2006
Quick Steps for Applying Configuration Files
Setting a File for Immediate Application
In this example, the configuration file configfile_1 exists on the switch in the /flash directory. When these
steps are followed, the file will be immediately applied to the switch.
steps are followed, the file will be immediately applied to the switch.
1 Check to verify that there are no timer sessions pending on the switch.
-> show configuration status
File configuration: none scheduled
2 Apply the file by executing the
configuration apply
command followed by the path and filename. If
the configuration file is accepted with no errors, the CLI responds with a system prompt.
-> configuration apply /flash/configfile_1.txt
->
Note. Optional. To verify that the file was applied, enter the
show configuration status
command. The
display is similar to the one shown here.
-> show configuration status
File configuration </flash/configfile_1.txt>: completed with 0 errors
For more information about this display, see “Configuration File Manager Commands” in the OmniSwitch
CLI Reference Guide.
CLI Reference Guide.
Setting an Application Session for a Date and Time
You can set a timed session to apply a configuration file at a specific date and time in the future. The
following example applies the bncom_cfg.txt file at 9:00 a.m. on July 4 of the current year.
following example applies the bncom_cfg.txt file at 9:00 a.m. on July 4 of the current year.
1 Check to verify that there are no current timer sessions pending on the switch.
-> show configuration status
File configuration: none scheduled
2 Apply the file by executing the
configuration apply
using the at keyword with the relevant date and
time.
-> configuration apply bncom_cfg.txt at 09:00 04 july
Note. Optional. To verify that the switch received this
configuration apply
request, enter the
show
configuration status
command. The display is similar to the one shown here.
-> show configuration status
File configuration </flash/working/bncom_cfg.txt>: scheduled at 07/04/02 09:00
For more information about this display see “Configuration File Manager Commands” in the OmniSwitch
CLI Reference Guide.
CLI Reference Guide.