Alcatel-Lucent OmniSwitch 9000 Guia De Configuração Rápida
May 2007
Connections and Cabling
17
Once your switch is properly installed, you should connect all
network and management cables required for your network
applications. Connections may include:
network and management cables required for your network
applications. Connections may include:
•
Serial cable to the console port
•
Ethernet cable to the Ethernet Management Port
(EMP) on the CMM
(EMP) on the CMM
•
Gigabit cables to all required XFPs or MiniGBICs
•
Ethernet cables to all required Ethernet Network
Interface (ENI) ports
Interface (ENI) ports
Serial Connection to the Console
Port
Port
The console port, located on the CMM module, provides a
serial connection to the switch and is required when logging
into the switch for the first time. By default, this RJ-45
connector provides a DCE console connection.
serial connection to the switch and is required when logging
into the switch for the first time. By default, this RJ-45
connector provides a DCE console connection.
Serial Connection Default Settings
The factory default settings for the serial connection are as
follows:
follows:
For information on modifying these settings, refer to
Connections and Cabling
baud rate
9600
parity
none
data bits (word size)
8
stop bits
1