Alpine ina-n033r Manual Do Utilizador

Caution
When you install this unit in your car, do not remove the

Detachable Front Panel.
If the Detachable Front Panel is removed during installation, you

might press too hard and warp the metal plate that holds it in place.

Caution
Do not block the unit's fan or heat sink, thus preventing air
circulation. If blocked, heat will accumulate inside the unit

and may cause a fire.

Slide mounting sleeve from main unit (see "Removal"
on this page). Slide the mounting sleeve into the
dashboard.

When your vehicle has the Bracket, mount the long hex
bolt onto the rear panel of the INA-N033R and put the
Rubber Cap on the hex bolt. If your vehicle does not
have the Mounting Support, reinforce the head unit
with the metal mounting strap (not supplied). Connect
all the leads of the INA-N033R according to details
described in the CONNECTION section.

Slide the INA-N033R into the dashboard. When the
unit is in place, make sure the locking pins are fully
seated in the down position. This can be done by
pressing firmly in on the unit while pushing the locking
pin down with a small screwdriver. This ensures that
the unit is properly locked and will not accidentally
come out from the dashboard. Install the Detachable
Front Panel.

Removal
1

Remove the detachable front panel.

2

Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see above drawing).
As each pin is unlocked, gently pull out on the unit to
make sure it does not re-lock before unlocking the
second pin.

3

Pull the unit out, keeping it unlocked as you do so.

∗

× 8)