Alpine nvd-z001 Manual Do Utilizador

Reference

54

If you encounter a problem, please review the items in the following checklist. This guide will help you
isolate the problem if the system is at fault. Otherwise, make sure the system is properly connected or
consult your authorized Alpine dealer.

Blown fuse

Ambient temperature over 50°C

Moisture condensation

The vehicle position changed after
the ignition was switched off.
• Movement on a ferry boat
• Rotation of a parking lot turntable
• Movement by tow truck

Poor satellite configuration

Measurement is 2
dimensional

The navigation screen is off.

The disc is dirty.

The pickup lens is dirty.

The remote control batteries are
wearing out.

While driving on the route, some
menu operations cannot be carried
out.

Auto reroute mode is not set.

Replace with a fuse of the prescribed rating.

Lower the temperature in the vehicle below 50°C, for
example by running for a while with the window open
or by using the air conditioner.

Allow enough time for the condensation to evaporate
(about 1 hour).

Drive for a while with GPS signal reception.

Move to a location where GPS satellite reception is
easy.

Press the ON (ON/OFF) button on the remote control.

Clean the disc.

Consult your Alpine dealer. (Do not use a lens cleaner
disc sold in the market.)

Replace the remote control batteries.

Move the vehicle to a safe location, stop, and engage
the parking brake, then carry out this operation.

Select “Setup” from the main menu, then select ON
for Auto reroute. (See page 46.)

No operation

The present vehicle
position cannot be
measured correctly.

The measurement
error is too large.

Screen not displayed

Cannot read disc is
displayed for a certain
operation.

Unstable operation

Cannot operate menu

No auto reroute