ASUS AT3IONT-I Manual Do Utilizador

2-10

Chapter 2: BIOS information

The items in this menu allows you to change the USB-related features. Select an item then 

press <Enter> to display the configuration options.

The Module Version and USB Devices Enabled items show the auto-detected values. If no 

USB device is detected, the item shows None.

Allows you to disable or enable the USB functions.  

Configuration options: [Disabled] [Enabled]

Allows you to enable or disable USB 2.0 controller.  

Configuration options: [Enabled] [Disabled] 

Allows you to enable or disable support for Legacy USB storage devices, including USB flash 

drives and USB hard drives. Setting to [Auto] allows the system to detect the presence of 

USB devices at startup. If detected, the USB controller legacy mode is enabled. If no USB 

device is detected, the legacy USB support is disabled.  

Configuration options: [Disabled] [Enabled] [Auto]

Allows you to configure the USB 2.0 controller in HiSpeed (480Mbps) or Full Speed 

(12Mbps). Configuration options: [FullSpeed] [HiSpeed] 

The following items may only appear when a USB storage device is plugged.

USB Mass Storage Reset Delay [20 Sec]

Allows you to set the maximum time that the BIOS waits for the USB storage device to 

initialize. Configuration options: [10 Sec] [20 Sec] [30 Sec] [40 Sec]

Emulation Type [Auto]

Allows you to select the emulation type. Configuration options: [Auto] [Floppy] [Forced 

FDD] [Hard Disk] [CDROM]

Allows you to enable or disable the onboard WLAN function.  

Configuration options: [Enabled] [Disabled]