ASUS p65up8-scsi Manual Do Utilizador

II. WINDOWS 95 DRIVERS

(Installation)

Existing System Installation

This procedure installs the SYMC8XX.MPD driver onto an existing Windows 95
system.

1. Boot Windows 95.

2. Click Start.  Move to Settings, Control Panel, and click.

3. Double-click on the System icon.

4. Click on the Device Manager tab.

NOTE: If the SCSI controllers entry, or the PCI NCR C8xx SCSI Host Adapter
entry do not exist, the system is probably using the ASPI8XX.SYS DOS ASPI
driver.  See the section Existing System Using ASPI8XX.SYS DOS ASPI Driver
below.

5. Either double-click on the SCSI controllers entry, or click once on the plus

sign to the left of it.

6. Select the PCI NCR C8xx SCSI Host Adapter entry.  Click the Properties button.

7. Click the Driver button.  The version of the currently active driver should

display in the File details section.

8. Click the Change Driver... button.

9. Even though you may have previously installed the SYMC8XX.MPD driver,

click the Have Disk... button to install a newer version.

10. Insert the Symbios Driver diskette in drive A: and select A:\WIN95 directory,

then click OK.  (If using drive B:, you must select it from the pick list.)

11. The Select Device dialog box should display “Symbios Logic 8xxxx PCI SCSI

Host Adapter”, where 8xxxx matches the installed adapter.  Click OK.

12. The Driver tab is updated to display the new driver files.

To install these driver files, click OK.  [Do NOT click the Change Driver...
button.]  The driver files are copied and a new driver database is built.

13. A “System Settings Change” dialog box is displayed.  Remove the flex disk

from the drive and click Yes to restart the computer.

At this point, the new driver is operational.  To verify this, see the section
“Verifying Correct Driver Installation”