ASUS p65up8-scsi Manual Do Utilizador

VI. UNIXWARE DRIVERS

3. Insert the SDMS PCI UnixWare driver diskette when prompted to insert the

Host Adapter diskette and press Enter.
When the driver is loaded, a message “C8xx driver isloaded” appears on the
screen.  If you want to install other host adapter drivers, then insert the IHV
HBA diskette provided with the UnixWare distribution package and press Enter.

4. Follow instructions on the screen or refer to the UnixWare Installation Hand-

book to complete installation.
NOTE: During the installation, if the driver does not find a hard disk on which
to install the operating system, it aborts the process.

5. At the end of the installation you might see a prompt to reinsert the driver

diskette. Insert the SDMS PCI UnixWare driver diskette and press Enter.  The
kernel is rebuilt and the system gets ready to boot from the SCSI disk drive.

6. Remove the driver diskette when prompted to do so and reboot the system.

Updating UnixWare 2.xx with the C8xx Driver

You may install the C8xx driver on a system currently running UnixWare by using
one of three different procedures. The method to use depends on the setup of your
system and on whether you want the system to remain running during this process.
By reviewing the following questions, you can determine which procedure to fol-
low.

If the answer is yes, then you MUST statically link the kernel and reboot the system.
Follow the instructions in sections:

        Loading the Package
        Configure for Statically Linked driver
        Rebuild the UnixWare Kernel

If the answer is yes then you want to install the driver as a dynamically loadable
driver. Follow instructions in sections:

        Loading the Package
        Configure for Dynamically Loadable driver
        Loading Loadable module.
If the answer is no to the above questions then follow instructions in sections:

        Loading the Package
        Rebuild the UnixWare Kernel

(Installation)