att 4695 Manual Do Utilizador
Operating Range
Your cordless telephone operates at the maximum power allowed by the Federal Communications
Commission (FCC). Even so, your handset and base unit can communicate over only a certain distance –
which can vary with the locations of the base unit and handset, the weather and the construction of your
home or office.
Commission (FCC). Even so, your handset and base unit can communicate over only a certain distance –
which can vary with the locations of the base unit and handset, the weather and the construction of your
home or office.
For best performance, keep both the base antenna and the telephone line cord fully extended when using
your handset away from the base.
your handset away from the base.
It is a good idea to make a few trial calls in and around your home or office to become familiar with the
operating range in your particular surroundings.
operating range in your particular surroundings.
If you go out of range: If you move out of range during a phone conversation, you will hear noise or
interference. To improve reception, move closer to the base.
interference. To improve reception, move closer to the base.
Using the Intercom and Page
Your AT&T Cordless Answering System can also work as a two-way intercom between the handset and
the base unit. This does not tie up your telephone line – you can still receive calls when using the intercom.
the base unit. This does not tie up your telephone line – you can still receive calls when using the intercom.
NOTE: The operating range for the intercom is about the same as for regular telephone calls.
You must be within range to turn the intercom on or off, or to page someone at the other end.
You must be within range to turn the intercom on or off, or to page someone at the other end.
Paging Someone at the Other End
If you are at the handset, you can page someone at the base unit, and vice versa.
If you are at the handset, press and release PAGE. This will sound a three-part paging tone at the base unit.
Press and release INTCM to activate the intercom. You can then speak with the person at the base unit
through the handset.
Press and release INTCM to activate the intercom. You can then speak with the person at the base unit
through the handset.
If the answering system in the base is busy answering a call or playing messages, you’ll get a buzzing
signal at the handset to indicate that the unit is unable to give you access to the intercom. When the base is
idle again, you’ll be able to use the intercom.
signal at the handset to indicate that the unit is unable to give you access to the intercom. When the base is
idle again, you’ll be able to use the intercom.
If you are at the base unit, press and release PAGE/FIND to signal the handset. This will sound a three-part
paging tone at the handset. When the person answers, speak toward the base.
paging tone at the handset. When the person answers, speak toward the base.
Answering a Page
If you are at the handset and hear the three-part paging tone, press and release INTCM. This turns on the
intercom and lets you speak to the person at the base.
intercom and lets you speak to the person at the base.
If you are at the base and hear the three-part paging tone, wait for the INTERCOM Light to go on and then
speak toward the base. You’ll hear the other person through the speaker.
speak toward the base. You’ll hear the other person through the speaker.
Ending an Intercom Conversation
To end an intercom conversation and turn off the intercom, press OFF on the handset.
You cannot turn the intercom off from the base unit; the person at the handset must press OFF to turn off
the intercom.
the intercom.