applied-energy monoblock chrome Manual Do Utilizador
READ AND SAVE THESE INSTRUCTIONS FOR THE BENEFIT OF THE USER
Important!
.
Ø This mixer tap is only to be used in conjunction with the standard “WS7” Water Heater.
It is not suitable for the remote version of this heater.
Ø All installation must be carried out by a qualified Plumbing Engineer.
Ø Installation must conform to current Water Bylaws of Appropriate Local Regulations.
Ø WARNING: THIS PRODUCT MUST BE EARTHED.
Ø Installation must conform to current Water Bylaws of Appropriate Local Regulations.
Ø WARNING: THIS PRODUCT MUST BE EARTHED.
Description
.
OPERATING DATA
Maximum hot water temperature is 80°C
Maximum inlet water pressure (static) is 7 bar.
INLET WATER
A tubular plastic pressure regulator is supplied with the Mixer Tap.
PRESSURE
This is inserted into the cold inlet pipe of the Mixer Tap
REGULATION
in line with the following table:-
STATIC INLET PRESSURE
ACTION
UP TO 1.5 bar
Omit plastic tube
BETWEEN 1.5 and 4 bar
Insert tube cut down to 90mm
BETWEEN 4 and 7 bar
Insert the entire plastic tube
The tubular plastic pressure regulator’s function is to minimise the mixing of cold inlet water with the stored hot
water in the heater.
WARNING: THE WS7 IS AN OPEN OUTLET WATER HEATER.
THERE SHOULD BE NO OTHER TAPS OR RESTRICTORS IN THE HOT OUTLET (MARKED RED ON THE
HEATER) SIDE OF THE CIRCUIT.
Installing the Chrome Monoblock Mixer Tap
.
IMPORTANT: Fit the mixer tap to the sink or worktop before attempting to connect any pipe work.
•
The Chrome Monoblock Mixer Tap should be located in a hole of a minimum diameter of 26mm in the
sink/worktop.
sink/worktop.
•
A large rubber “O”-Ring (supplied), should be located directly under the flange on the underside of the mixer
block, between the unit and the sink/worktop.
block, between the unit and the sink/worktop.
•
A large flat rubber washer (supplied), should be located around the threaded portion of the mixer block
directly under the sink-worktop,
directly under the sink-worktop,
•
A large plastic nut (supplied), should be screwed onto the threaded part of the mixer block with the flange
uppermost. Do not over tighten the plastic nut.
uppermost. Do not over tighten the plastic nut.
Note: - Some extra small parts are included in the kit which are not necessary to complete the installation with the
WS7 water heater.
Monoblock Chrome
Mixer Tap
Installation and User Instructions
(To be left with user after installation)