autotech 10.525.1128k Manual Do Utilizador

Phone 949.240.4000  Fax 949.240.0450

32240-E Paseo Adelanto, San Juan Capistrano, CA 92675

Part Number:   10.525.1128K
Description:  

 

These performance swaybars utilize Autotech’s unique sliding endlink design

that prevents binding of the bar (and preloading of the suspension) due to
locational differences between the mounting points of the rear suspension and the
swaybar itself.

1. jackstands  

1. rear swaybar

2. electric drill and 1O.5mm (27/64")bit 

2. (4) poly bushings

3. silicone lubricant 

3. (4) steel ring mounts

4. metric wrenches, 13 to 17mm 

4. (2) 1Omm rod ends

5. tape measure 

5. (6) 1Omm hardened washers

6. moly grease 

6. (2) 1Omm thin jam nuts (1128K only)

 

7. (2) 1Omm nylock nuts

 

8. (2) M10x90 shock bolts

1. Apply a generous amount of waterproof grease to the inside of the bushings, and some sili-

cone spray along each of the bends on the swaybar.

2. Slide the two inboard mounts onto the swaybar and push them past both bends so that 

they  end  up  on  the  middle,  straight  section  of  the  swaybar.  The  inboard  mounts  will  be 
installed on the axlebeam when they are as far apart from each other as possible with-
out  overlapping  any  of  the  bends  on  the  bar.  Measure,  and  take  note  of  this  distance. 
The  distance  from  stud  to  stud  on  the  inboard  mounts  should  be  approximately  as  fol-
lows:

 

 

A2/A3 Chassis  29 inches

 

 

A4 Chassis 

25 inches

3. Raise the rear of the car and place it on jackstands. Be sure that the car is in gear, the 

front wheels are chocked, and that it cannot roll.

www.autotech.com

A2/A3 = 29.0 in

A4/B5 = 25.0 in