autotech 10.425.1426k Manual Do Utilizador
(cont)
10. Finally, re-attach the subframe to the body. Tighten bolts 1 and 2 (fi g. 1) to 52 ft lbs +1/4
turn (90 degrees). Tighten bolt 3 (fi g. 1) to 48 ft lbs.
11. Loosen and remove the rear ball-joint attachment bolt.
12. Attach the supplied bracket to the A-arm using the rear ball-joint attachment bolt and
the supplied hardware (the new bolt, washer, and nut are used in the original hole for the
end link.)
end link.)
13. Attach the end link to the new bracket. The inside hole is the softest setting. For the
stiffest setting, use the outer hole.
* To use the outer hole, you must fi rst install the hex end-link spacer in the bar end. This
extends the reach of the swaybar, allowing the drop link to mount to the outermost hole
on the new bracket without excessive preload. Although it may reach without it, don’t use
the outer hole without the spacer.
on the new bracket without excessive preload. Although it may reach without it, don’t use
the outer hole without the spacer.
soft medium
fi rm*