australian-monitor amis di1 Manual Do Utilizador
AMISDI1
Passive Direct Injection Box
Introduction
The Australian Monitor Installation Series DI1 is a passive direct injection
box that features a balanced XLR output, a 6.35 mm TRS through output, 3
stage pad offering up to 40dB of attenuation & a ground lift switch for
hum elimination. As part of the AMIS Contractor Tools range, the AMIS DI1
is an inexpensive passive DI that is integral to a wide variety of installations.
box that features a balanced XLR output, a 6.35 mm TRS through output, 3
stage pad offering up to 40dB of attenuation & a ground lift switch for
hum elimination. As part of the AMIS Contractor Tools range, the AMIS DI1
is an inexpensive passive DI that is integral to a wide variety of installations.
Description
• 6.35mm TRS Jack Input: This will accept balanced or unbalanced
signals from a program source or instrument.
• 6.35mm TRS Jack Thru Output: This balanced output allows for a
direct output link to an instrument amplifier.
• 3 Stage input Pad: This 3 stage switch allows 0dB, 20dB or 40dB of
input attenuation so differing sources can accommodated.
• GND Lift Switch: When this switch is in “ground” position pin1 of both
the input & the output are connected. When this switch is in “lift”
position these grounds are separated. This switch is used to
eliminate hum that may be present.
position these grounds are separated. This switch is used to
eliminate hum that may be present.
• Balanced XLR Output: This balanced XLR output is for connection to
a mixing console, signal processor etc.
Specifications
Attenuation
Switch:
0dB, 20dB or 40dB selectable
Frequency
Response: 15Hz-30kHz
Dimensions:
74mm x 45mm x 130mm
Weight:
650g