australian-monitor amis1202p Manual Do Utilizador
Front Panel Features
Power Switch
The black rocker switch on the right hand side of the front panel is used to switch the amplifier on and off.
The ‘up’ position is on. When the amplifier is connected to an appropriate AC power source and is
switched on, the blue power LED will illuminate. This switch will not switch DC power on or off in DC
operation. In DC operation mode, the amplifier is always on and the blue power LED will always be
illuminated.
The ‘up’ position is on. When the amplifier is connected to an appropriate AC power source and is
switched on, the blue power LED will illuminate. This switch will not switch DC power on or off in DC
operation. In DC operation mode, the amplifier is always on and the blue power LED will always be
illuminated.
On LED
The blue “On” LED above the power switch will illuminate when the amplifier is connected to mains
power and is switched on. In 24vdc operation the LED will always be on.
power and is switched on. In 24vdc operation the LED will always be on.
Signal LED
The green “Signal” LED’s located next to the On LED indicate that the AMIS1202P is receiving audio
signal via its line level inputs. One LED is provided per channel. The signal LED’s are a simple way of
trouble-shooting installations especially in multi amplifier projects. At a glance the signal LED’s will
indicate that audio is reaching the amplifier.
signal via its line level inputs. One LED is provided per channel. The signal LED’s are a simple way of
trouble-shooting installations especially in multi amplifier projects. At a glance the signal LED’s will
indicate that audio is reaching the amplifier.
Rack Mounting
The AMIS1202P is supplied with rack ears attached to allow mounting within a standard 19” equipment
rack. As is the case with almost all audio products, adequate ventilation and air flow is required. When
installing multiple AMIS amplifiers within the one rack, it is recommended that at least one rack unit of
ventilation space is left between every two amplifiers. For table or shelf mounting, the rack ears can be
removed using a screwdriver. Once the rack ears are removed, please reinstall the screws.
rack. As is the case with almost all audio products, adequate ventilation and air flow is required. When
installing multiple AMIS amplifiers within the one rack, it is recommended that at least one rack unit of
ventilation space is left between every two amplifiers. For table or shelf mounting, the rack ears can be
removed using a screwdriver. Once the rack ears are removed, please reinstall the screws.
Rear Panel Features
AC Power Inlet
The 3 pin IEC power inlet is located on the bottom left of the rear panel and accepts a standard mains
power lead fitted with an IEC connector.
The inlet is equipped with an in-built AC fuse holder fitted with an 8 Amp slow blow fuse plus a spare
fuse.
power lead fitted with an IEC connector.
The inlet is equipped with an in-built AC fuse holder fitted with an 8 Amp slow blow fuse plus a spare
fuse.