australian-monitor amis lsc1 Manual Do Utilizador

 

 

 

 

 
The Australian Monitor Installation Series LSC1 line splitter/combiner 

produces 2 balanced XLR signals, (1 direct, 1 transformer isolated) from a 
single balanced XLR line level input. The AMIS LSC1 provides a ground lift 

switch to eliminate hum, & as part of the AMIS Contractor Tools range, the 

AMIS LSC1 is an inexpensive splitter/combiner that has a multitude of uses 
in a wide variety of installations. 
 

 

 

•  Input: This balanced XLR Line level input receives signal from a line 

source. 

•  Thru Output: This balanced XLR output is wired in parallel to the Input 

& provides a balanced signal output. 

•  Output: This XLR output provides a transformer isolated output of the 

input signal feed. 

•  GND Lift Switch: When this switch is in “ground” position pin1 of both 

the input & the output are connected. When this switch is in “lift” 
position these grounds are separated. This switch is used to 
eliminate hum. 

 

 

 
 Input 

 6 K Ohms @ 1kHz

 

 

600 Ohm 

 

95mm x 73mm x 40mm 

 

+22 dBu @ 1 kHz .007% THD 

 

10Hz-50kHz 

 
Note: Unbalanced sources should be wired Pin 2 Hot, Pin 3 Cold, with Pin 1 
linked to Pin 3.