Atlantic Technology 642e SB Manual Do Utilizador
11
Instruction Manual
Subwoofer Troubleshooting Guide
Subwoofer Troubleshooting Guide
Once your subwoofer is set up, you should have many years of maintenance free enjoyment from your system. However, if you should encounter a
problem, refer to the following guide to help you find the solution. If a problem persists, you should contact your local authorized Atlantic Technol-
ogy dealer.
problem, refer to the following guide to help you find the solution. If a problem persists, you should contact your local authorized Atlantic Technol-
ogy dealer.
Model 642e SB Specifications
Type/Features
Powered subwoofer, sealed enclosure
High efficiency tracking amplifier
2-inch, four layer vented aluminum voice coil, vented motor
Continuous 40–140Hz crossover, 18dB/octave low pass output
Variable low level stereo inputs and low level outputs
Absolute phase invert switch
Auto signal sensing on/off/bypass
Bass Driver
12” long-throw composite cone
Output Power
300W RMS
Distortion (amplifier)
<0.5%
Frequency Response
25Hz – 300Hz ±3 dB
Low Level (line)
20kΩ
Peak Output
105dB SPL into 2000 cubic Feet
Dimensions (WxHxD)
19.00 x 21.00 x 18.50in; 483 x 534 x 470mm
Weight
65lbs/29.5kg
Power Requirements
110V AC 50/60Hz; 240V AC 50/60Hz
Specifications are those in effect at the time of printing. Atlantic Tech-
nology reserves the right to change specifications or designs at any time
without notice. THX is a registered trademark of Lucasfilm Ltd. Dolby
Digital, Dolby Stereo, and Dolby Pro Logic are trademarks of Dolby Labo-
ratories Licensing Corporation. DTS is a registered trademark of Digital
Theater Systems, Inc.
nology reserves the right to change specifications or designs at any time
without notice. THX is a registered trademark of Lucasfilm Ltd. Dolby
Digital, Dolby Stereo, and Dolby Pro Logic are trademarks of Dolby Labo-
ratories Licensing Corporation. DTS is a registered trademark of Digital
Theater Systems, Inc.
Problem
Possible Cause
Possible Solution
No bass output
AC power cord unplugged or
Plug into a working outlet.
plugged into a non-working outlet.
Input cables not securely
Check all connections, then try another
connected or defective.
input cable.
Audible buzz or hum
Input cable not securely connected
Check all connections, then try another
or defective.
input cable.
Ground loop through antenna or
Test by disconnecting antenna and/or cable
cable TV system input.
system input leads. If hum goes away, install
isolation balun(s) at that point.