Avaya cm084-2-amps Manual Do Utilizador

WARNING:
Drilling into the fl oor or console can permanently damage the  
vehicle.  Use caution and consult a mobile install professional to 
avoid drilling into the gas tank, electrical system or other highly 
sensitive vehicle components.  

Arkon Resources, Inc. is not responsible for any damages caused 
to your car, your device, or yourself due to the installation or use of 
the pedestal mount.

Arcadia, CA 91006 USA

Made in Taiwan

© Copyright 2007 Arkon Resources, Inc.

Consumer Hotline:
(USA)    (800) 841-0884
(INT’L)   (626) 254-9005
                Mon-Fri. 9am-5pm, PST

Find a safe, fl at location on the interior of the vehicle’s fl oor or 
console to mount the pedestal. 

Using the base as a template, drill three 1/8” holes and attach 
base with the included self-tapping screws.  Snap screw caps  
in place over the screws on the base.

Screw the 9” fl exible steel arm securely into the base.

Step 1. 

Step 2.

Step 3.

Package Contents:
(1) CM084-2-AMPS - 9” Universal fl exible mounting arm
      Includes threaded screws (3), screw caps (3), and 
      machine screws (4) for connecting to AMPS pattern
(1) AP032 - Dual T-tab to AMPS horizontal adapter plate

Tools required for fl oor or console mounting - drill and screwdriver. 

Note: Do not twist the cradle or device while mounted on top of the
pedestal to adjust the steel shaft as this can break the dual T-slots.

Precaution: This solution requires drilling which may damage your 
vehicle.  Consult with a mobile install professional prior to installation.  
Arkon Resources, Inc. assumes no responsibility of liability for damage 
to your vehicle.

Do not install this pedestal in an airbag deployment zone
or where windshield vision may be impaired.

Attach the 4 hole AMPS pattern plate (if necessary) to the 
other end of the mounting arm with the included large hex 
nuts.  Fasten the AMPS to dual T-tab adapter plate to the 
AMPS pattern plate with the included screws and nuts.

Adjust the gooseneck by bending with both hands to the 
desired location of the cradle or device.  

Attach the dual T-slots on the back of the cradle or device
to the dual T-tab adapter plate.

Step 5. 

Step 6.

Step 7. 

CM084-2-AMPS pedestal
(Adapter plate shown attached to pedestal)