Avaya gps-dg9208g3 Manual Do Utilizador

©

 International, Eagan, MN  2009

Pro.Fit International, Inc.® may not be held liable for any damage to a vehicle before, during or after the installation or removal of this VSM 
G3TM.  Pro.Fit International may not be held liable for any personal injury resulting from accident or improper installation. Pro.Fit International, 
Inc.®  1335 Eagandale Court,  Eagan,  MN 55121, Ph: 651.688.3588 or 800.388.0073  Fx: 651.688.9876

PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS VSM G3      

All instructions assume a drivers seat vantage point.  Caution is advised when removing and reassembling 

wood or plastic parts of a dash. Applying unnecessary force or  pressure may cause a piece to crack or break.

 Dash Trim Removal Tool (DTRT), Phillips screwdriver
 VSM G3, A Plate, J Stem
 Right of Radio

TOOLS REQUIRED:   

PARTS INCLUDED: 

LOCATION:

Step 1:  Place the DTRT in between the radio 
bezel and the dash molding Photo #1.  Gently 
use the DTRT in a twisting motion around the 
radio bezel releasing a series of eight (8) 
retainer clips.  Do not disconnect any wiring to 
the bezel and simply set the radio bezel off to 
the side.

Step 2:  Remove the two Phillips screws securing 
the right side of the radio to the dash molding 
and carefully set them off to the side.  Place 
the VSM G3 flush to dash molding over the screw 
holes and evenly tighten the VSM G3 to the right 
side of the radio molding as pictured in Photo 
#2.

Step 3:  Once the VSM G3 is flush and secured 
to the right side of the radio, replace the radio 
bezel back into its secured original position.  
You have successfully installed your VSM G3!

Note: Note: See the Assembly Instructions for G3 

Components for additional information.