HP ml350 Manual Do Utilizador
Removal and replacement procedures 35
3.
Remove the hard drive.
To replace the component, reverse the removal procedure.
IMPORTANT:
When installing a x3/x1 SAS cable in a SFF system, HP recommends that the x3
part of the x3/x1 cable be linked to the SAS hard drive backplane connector that corresponds
to hard drive slots 1 to 4. In this setup, hard drive slot 1 will not be available, but since hard
drive slots 2 to 4 will be connected, one continuous volume can be created. All drive slots will
be available in LFF systems.
be available in LFF systems.
Hard drive cage
To remove the component:
1.
Power down the server.
2.
Do one of the following:
o
Unlock and remove the bezel ("
o
Extend the server from the rack (on page
3.
Remove the access panel.
4.
Remove the rack bezel (rack servers only) ("
5.
Disconnect the power and data cables.