Nikon SB-28 Manual Do Utilizador
Turning power on and off
To turn the SB-28 on and off, depress and hold the
= button for
approx. 0.5 sec.
Standby function
If both the SB-28 and camera are not used for after approx. 80 seconds,
the SB-28 shuts off automatically to conserve battery power. This is called
the standby function.
the SB-28 shuts off automatically to conserve battery power. This is called
the standby function.
Canceling and setting the standby function
1
Press the
= button for approx. 0.5 sec. to turn the SB-28 off.
2
Hold down the
µ button as you press the = button.
—The SB-28’s standby mode indicator
: on the LCD panel appears when
the function is set and disappears when it is not set. Perform steps 1 and 2 to
cancel it or reset it.
cancel it or reset it.
• The standby function is preset when the SB-28 is shipped from the factory.
(Check that the standby mode indicator
: appears on the LCD panel
when the SB-28 is turned on.)
When carrying the SB-28 in your camera bag with the standby
function set, make sure to turn off the flash unit to avoid accidental
battery drain.
function set, make sure to turn off the flash unit to avoid accidental
battery drain.
To turn the SB-28 on again after it enters the standby mode,
you can:
you can:
• Lightly press the shutter release button (except cameras in Group VII).
• Press the
• Press the
~ button on the SB-28.
• Press the SB-28’s
= button.
15
Turning the SB-28 on and off / Standby function