Samsung ba-716w Manual Do Utilizador

16

1.If your arm measures 9"-13" around, use the 

regular cuff included with your monitor. If your  
arm measures 13"-17" around, please use a  
Walgreens Large Cuff (Model #BC-200W).

2.Before taking a measurement, read the  

Important Reminders on pages 14-15. Make  
certain the cuff plug is inserted securely in the  
monitor and the cuff is assembled properly.  
Remove any constricting or thick clothing from  
your upper arm. 

3.Slide your arm through the cuff loop. The cuff  

should be positioned on your bicep about 1/2"  
above the elbow. With your palm facing up,  
the red arterial marker should be in the center  
of your arm over the brachial artery. The cuff  
tube should run down the center of your arm.  
Instructions are also printed on the cuff for  
reference. 

4.Secure the cuff around your arm using the  

velcro so it fits securely but is not too tight.  
You should be able to place 2 fingers in  
between the cuff and your arm. 

5.The velcro tab should fall within the "OK"  

range printed on the cuff for proper use. If your  
arm is larger than 13" around and the cuff  
does not fall within the "OK" range, please use  
a Walgreens Large Cuff (Model #BC-200W). 

6. Relax your arm and place your elbow on the  

table.

..

..........................

17

1.

Once the cuff is properly applied and you are seated with your  
feet flat on the floor you are ready to take a measurement.

2.

Press the

(Up) or 

(Down)  button  

and you will see a number appear: 1 or 2.  
These are each of the 2 party memory  
zones explained on page 10 (Special  
Features).

*If you select zone No. 1 your blood 

pressure will be recorded as on of the 48 readings available for   

that zone. The same is true for zone 2. When taking  

measurements, be sure and select the correct zone number so  

that the measurement is stored in the appropriate zone.

3.

Press the START/STOP button. The monitor will begin to  

inflate to 160mmHg. If the monitor senses that you require a

higher inflation level, it will automatically increase the air  

pressure to the level that's right for you..

4.

You will feel the cuff get tighter around  
your arm - this is normal. It should not  
inflate to the point of discomfort. If this  
occurs, the cuff may be secured too tightly.  
To  stop the inflation, press START/STOP.  
The cuff will deflate automatically. Rewrap  
the cuff allowing more room between your  
arm and the cuff.

Inflation

mmHg

mmHg

MODE

MEMORY

mmHg