Samsung dvd-v940k Manual Do Utilizador
ENG-8
Tuning Your Television for the
DVD-VCR
DVD-VCR
You must tune your television for the DVD-VCR only if
you are not using a AV cable
you are not using a AV cable
➢
To view pictures from your DVD-VCR when a AV
cable is used, the television must be set to the
audio/video mode (AV).
cable is used, the television must be set to the
audio/video mode (AV).
1
Switch on the television.
2
Switch on the DVD-VCR by pressing STANDBY/ON
on the front of the DVD-VCR or STANDBY/ON on
the remote control.
on the front of the DVD-VCR or STANDBY/ON on
the remote control.
3
Select a programme position on the television to be
reserved for use with your DVD-VCR.
reserved for use with your DVD-VCR.
4
Insert the video cassette in the DVD-VCR. Check
that the DVD-VCR starts reading the cassette; if
not, press
that the DVD-VCR starts reading the cassette; if
not, press
❿
II
button.
5
Start a scan on your television or set the television
to UHF channel 36.
to UHF channel 36.
6
Fine tune the television until the pictures and sound
are obtained clearly.
are obtained clearly.
7
If you cannot find the pictures and sound, or there
is interference from nearby channels, it may be
necessary to change the setting of the DVD-VCR
output channel (see Setting the DVD-VCR Output
Channel on page 14 and Problems and Solutions
on page 45).
is interference from nearby channels, it may be
necessary to change the setting of the DVD-VCR
output channel (see Setting the DVD-VCR Output
Channel on page 14 and Problems and Solutions
on page 45).
8
When the picture and sound are perfectly clear,
store this channel at the desired programme
position on the television.
Result: That programme is now reserved for use
store this channel at the desired programme
position on the television.
Result: That programme is now reserved for use
with your DVD-VCR.
Plug & Auto Set up
Your DVD-VCR will automatically set itself up when it
is plugged into the mains for the first time. TV stations
will be stored in memory. The process takes a few
minutes. Your DVD-VCR will then be ready for use.
is plugged into the mains for the first time. TV stations
will be stored in memory. The process takes a few
minutes. Your DVD-VCR will then be ready for use.
1
Connect the coaxial cable as indicated on page 6.
(Connecting Your DVD-VCR to the TV Using the
Coaxial Cable)
(Connecting Your DVD-VCR to the TV Using the
Coaxial Cable)
2
Plug the DVD-VCR into the mains.
Result: The Auto Setup is started automatically.
Result: The Auto Setup is started automatically.
3
Select the required language by pressing the
or
❷
buttons.
4
Press OK to store the language selected.
Result: A message appears.
Result: A message appears.
5
Press OK to start the auto scanning.
◆
The number of stations automatically stored by
the VCR depends on the number of stations
that it has found.
the VCR depends on the number of stations
that it has found.
6
The current time and date are displayed
automatically. Check the date and time. if it is :
automatically. Check the date and time. if it is :
◆
Correct, Press RETURN button twice to exit the
menu.
menu.
◆
incorrect, see page 10.
➢
Auto preset can be performed by pressing ■ on
the front panel continuously for 5 seconds or
more with no tape inserted in VCR mode.
the front panel continuously for 5 seconds or
more with no tape inserted in VCR mode.