Juniper CBL-M40-PWR-AU Manual Do Utilizador
Provide Power to the Router
M40 Internet Router Hardware Guide
122
4.
Carefully thread the cable through the hooks in the cable management system at the
upper front of the chassis (see Figure 1), to prevent the cable from dislodging or
developing stress points. Secure the cable so that it is not supporting its own weight as it
hangs to the floor. Place excess cable out of the way in a neatly coiled loop in the cable
management system. Placing fasteners on the loop helps to maintain its shape.
upper front of the chassis (see Figure 1), to prevent the cable from dislodging or
developing stress points. Secure the cable so that it is not supporting its own weight as it
hangs to the floor. Place excess cable out of the way in a neatly coiled loop in the cable
management system. Placing fasteners on the loop helps to maintain its shape.
Figure 50: Connect Cable to a PIC
Provide Power to the Router
Connect the router to external power sources and power it on by performing the following
procedures:
procedures:
Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can
damage the cable and cause problems that are difficult to
diagnose.
radius. An arc smaller than a few inches in diameter can
damage the cable and cause problems that are difficult to
diagnose.
Never let fiber-optic cable hang free from the connector.
Do not allow fastened loops of cable to dangle, which
stresses the cable at the fastening point.
Do not allow fastened loops of cable to dangle, which
stresses the cable at the fastening point.
1034
Precharge pins