Juniper CBL-M40-PWR-AU Manual Do Utilizador
Maintain and Replace the Power Supplies
Replace an AC Power Supply
139
10. Insert the appliance coupler end of the power cord into the appliance inlet on the power
supply faceplate and insert the plug into an AC power source receptacle. Verify that the
power cord does not block access to router components or drape where people could
trip on it.
power cord does not block access to router components or drape where people could
trip on it.
11. Press the power switch on the power supply to the
ON
(
|
) position. Verify that the green
LED labeled
OK
on the power supply faceplate eventually lights steadily.
Figure 54: Install an AC Power Supply
After a power supply is turned on, it can take up to 60
seconds for status indicators—such as LEDs on the power
supply,
seconds for status indicators—such as LEDs on the power
supply,
show chassis
commands, and messages on the
craft interface LCD—to indicate that the power supply is
functioning normally. Ignore error indicators that appear
during the first 60 seconds.
functioning normally. Ignore error indicators that appear
during the first 60 seconds.
If the router is completely powered down when you power
on the power supply, the Routing Engine boots as the
power supply completes its startup sequence. If the
Routing Engine finishes booting and you need to power
down the router again, first issue the CLI
on the power supply, the Routing Engine boots as the
power supply completes its startup sequence. If the
Routing Engine finishes booting and you need to power
down the router again, first issue the CLI
request system halt
command. For complete instructions,
If after powering on the power supply you must power it
off, wait at least 60 seconds. After powering off a power
supply, wait 60 seconds before turning it back on.
off, wait at least 60 seconds. After powering off a power
supply, wait 60 seconds before turning it back on.
1035
Safety interlock lever
Captive
screw
screw
Extractor/inserter