Sony ad-cwrf35 Manual Do Utilizador
EN
15
SPECIFICATIONS
Compact disc changer (ADC-M35)
System
Compact disc digital audio
system
system
Frequency response
5 Hz–20 kHz
Wow and flutter
Below measurable limit
Signal to noise ratio
97 dB
Outputs
Line output (for changer
connector only)
connector only)
Operating temperature
–10 °C to 55 °C
Dimensions
289 x 77 x 200.5 mm (w/h/d)
(11
(11
1
/
2
x 3
1
/
8
x 8 in.)
Weight
2.8 kg
(6.16 lbs.)
(6.16 lbs.)
Power requirement
12 V DC car battery
(negative ground)
(negative ground)
D/A converter
1 bit DAC, 8 times over
sampling
sampling
Sampling rate
44.1 kHz
Disc size
120 mm
Supplied accessories Disc magazine (1)
Mounting kit (1 set)
Connecting cable (5 m)
(16.4 ft.) (1)
Connecting cable (5 m)
(16.4 ft.) (1)
Power unit & FM modulator
Transfer frequency
88.7/89.1 MHz switchable
Dimensions
126 x 65 x 31 mm (w/h/d)
(5 x 2
(5 x 2
5
/
8
x 1
1
/
4
in.)
Weight
300 g (10.5 lb.)
Wired remote control
Dimensions
134 x 48 x 21 mm (w/h/d)
(5
(5
3
/
8
x 1
15
/
16
x
27
/
32
in.)
Cord length
1.4 m (4.59 ft.)
Weight
180 g (6.3 lb.)
Wireless remote control
Dimensions
64 x 100 x 20 mm (w/h/d)
(2
(2
5
/
8
x 4 x
13
/
16
in.)
Weight
60 g (2.1 lb.)
Design and specifications are subject to change without
notice.
notice.
Error codes
In the following cases the corresponding error
code indication will be displayed. Follow the
suggestions below to solve the problem. If the
error code indication does not disappear, consult
an AIWA service center.
code indication will be displayed. Follow the
suggestions below to solve the problem. If the
error code indication does not disappear, consult
an AIWA service center.
ERROR01
The disc magazine is not properly
inserted in the compact disc
changer. Re-insert the magazine.
inserted in the compact disc
changer. Re-insert the magazine.
ERROR02
No discs are loaded into the disc
magazine. Insert discs properly.
magazine. Insert discs properly.
ERROR03
Focus error. Check that the discs
are loaded properly into the disc
magazine (right side up, etc.)
are loaded properly into the disc
magazine (right side up, etc.)
ERROR04
Problem with the compact disc
changer. Reset the unit by
pressing the reset button. If this
does not correct the problem,
consult an AIWA service center.
changer. Reset the unit by
pressing the reset button. If this
does not correct the problem,
consult an AIWA service center.
ERROR05
The compact disc changer is
overheated. Allow the changer to
cool off by moving the vehicle out
of direct sunlight.
overheated. Allow the changer to
cool off by moving the vehicle out
of direct sunlight.
Reset button
Press the button either on the wired remote
control or the compact disc changer by inserting
the tip of a pointed object such as a ball-point pen
or toothpick into the opening to reset the unit
when the compact disc changer does not operate
properly. Press to reset the unit after a
malfunction. Note that the memory contents will
be erased upon your pressing the reset button.
(see page 3)
control or the compact disc changer by inserting
the tip of a pointed object such as a ball-point pen
or toothpick into the opening to reset the unit
when the compact disc changer does not operate
properly. Press to reset the unit after a
malfunction. Note that the memory contents will
be erased upon your pressing the reset button.
(see page 3)