Sony cyber-shot dsc-v1 Manual Do Utilizador

Página de 132
98
Shooting still images/movies
The battery pack runs 
down too quickly.
• You are shooting/viewing images in an 
extremely cold location.
• The DC plug is dirty so the battery pack is not 
charged enough.
• The battery pack is dead (page 121).
p Clean the pins of the AC Adaptor with a cotton swab, etc., and 
charge the battery pack (page 10).
p Replace the battery pack with a new one.
You cannot turn on the 
camera.
• The battery pack is not installed correctly.
• The AC Adaptor is disconnected. 
• The battery pack is discharged.
• The battery pack is dead (page 121).
p Install the battery pack correctly (page 10).
p Properly connect the AC Adaptor (page 13).
p Install a charged battery pack (page 10).
p Replace the battery pack with a new one.
The power turns off 
suddenly. 
• If you do not operate the camera for about three 
minutes when using a battery pack, the camera 
turns off automatically to prevent wearing down 
the battery (when [Power Save] is [On] after 90 
seconds) (page 14).
• The battery pack is discharged. 
p Turn on the camera again (page 14) or use the AC Adaptor 
p Replace it with a charged battery pack (page 10).
Symptom
Cause
Solution
The LCD screen is not 
turned on even when the 
power is turned on.
• The power was turned off with the LCD screen 
turned off the last time you used the camera.
p Turn on the LCD screen (page 28).
The subject is not visible 
on the screen.
• The mode dial is not set to 
, P, S, A, M, 
SCN or
 
 (Clip Motion).
p Set it to 
, P, S, A, M, SCN or
 
 (Clip Motion) (pages 20 
and 79).
The image is out of focus.
• The subject is too close. 
• The 
 (Twilight mode) or 
 (Landscape 
mode) is selected for the Scene Selection 
function.
• The focus preset function is selected.
p Record in the macro recording mode. Make sure to position the 
lens farther away from the subject than the shortest shooting 
distance when shooting (page 24). 
p Set it to other modes (page 63)
p Cancel the function (page 49).
Symptom
Cause
Solution