Sony DHC-MD313 Manual Do Utilizador
33
Marking track
numbers
numbers
1
Press r REC. The MD stands by for
recording.
recording.
2
Press PLAY MODE until “PGM” or
“SHUFFLE” disappears.
“SHUFFLE” disappears.
3
Press EDIT then press +/–
repeatedly until “LevelSync ?”
appears.
repeatedly until “LevelSync ?”
appears.
4
Press ENTER/YES.
“LevelSync ON ?” appears.
5
Press ENTER/YES again.
“LEVEL-SYNC” lights up.
6
Press MD ·∏.
Recording starts.
To stop recording
Press MD π.
To cancel automatic track marking
1 Press EDIT during recording.
2 Press +/– repeatedly until “LevelSync ?”
2 Press +/– repeatedly until “LevelSync ?”
appears.
3 Press ENTER/YES.
“LevelSync OFF ?” appears.
4 Press ENTER/YES again.
“LEVEL-SYNC” disappears.
When “LEVEL-SYNC” disappears, a track
number is marked only at the beginning of
each recording.
number is marked only at the beginning of
each recording.
Notes
• You may not mark track numbers auto matically if
the sound source to be recorded is noisy (e.g,.
tapes or radio programmes).
tapes or radio programmes).
• The MD recording is complete only after all the
recording information is entered to TOC at which
point TOC stops flashing and goes out. Be careful
disconnect the mains lead or move the deck before
this point. Before disconnecting the mains lead, do
the following:
– Remove the MD.
– Press POWER, to turn off the system.
point TOC stops flashing and goes out. Be careful
disconnect the mains lead or move the deck before
this point. Before disconnecting the mains lead, do
the following:
– Remove the MD.
– Press POWER, to turn off the system.
continued
When you record from this system’s CD
(digital recording), the track numbers are
automatically marked. In addition, you can
mark track numbers:
• At any point while recording.
(digital recording), the track numbers are
automatically marked. In addition, you can
mark track numbers:
• At any point while recording.
• Automatically while analog recording.
Marking track numbers at
a specific point while
recording
a specific point while
recording
The “LEVEL-SYNC” is factory set to ON.
If “LEVEL-SYNC” disappears, do step 1
through 5 to turn ON. Track numbers are
automatically marked when the input signal
is under a certain level for more than two
seconds and then exceed the previous level.
through 5 to turn ON. Track numbers are
automatically marked when the input signal
is under a certain level for more than two
seconds and then exceed the previous level.
–– Level-Synchro Recording
MD π
2
6
1
MD §
3
4,5