Sony HD 3CCD Manual Do Utilizador
In
s
ta
llat
ion
a
ion
a
nd
Conne
c
tio
ns
Installation
51
2
Insert an optional interface board into the card slot.
Align both ends of the interface board with the
sliders inside the slot, then insert the board securely
as far as it will go.
Align both ends of the interface board with the
sliders inside the slot, then insert the board securely
as far as it will go.
3
Tighten the two screws on the interface board.
To remove the interface board
Loosen the two screws on the interface board and pull
the board out straight and slowly.
the board out straight and slowly.
Installing the Camera
To install the camera on a desk
Place the camera on a flat surface.
If you have to place the camera on an inclined surface,
make sure that the inclination is less than ±15 degrees,
so that the pan/tilt performance is guaranteed, and take
If you have to place the camera on an inclined surface,
make sure that the inclination is less than ±15 degrees,
so that the pan/tilt performance is guaranteed, and take
an appropriate countermeasure to prevent the camera
from falling.
from falling.
Notes
• Do not grasp the camera head when carrying the
camera.
• Do not turn the camera head by hand. Doing so may
result in the camera malfunctioning.
To attach the camera to a tripod
Attach a tripod to the screw hole used for attaching a
tripod on the bottom of the camera.
The tripod must be set up on a flat surface and tightened
firmly by hand.
Use a tripod with screws of the following specifications.
tripod on the bottom of the camera.
The tripod must be set up on a flat surface and tightened
firmly by hand.
Use a tripod with screws of the following specifications.
Interface board
(not supplied)
(not supplied)
1
/
4
-20UNC
= 4.5 mm – 7 mm
= 0.18 – 0.27 inches
= 0.18 – 0.27 inches