Sony 4-114-858-12(1) Manual Do Utilizador

b

• The setting is not effective when you set the 

INPUT1 switch to LINE.

x

You can adjust the input signal level from 
INPUT1.
You can select from [-18dB], [-12dB], 
[-6dB], [0dB], [+6dB] and [+12dB]. The 
default setting is [0dB].

b

• The setting is not effective when you set the 

INPUT1 switch to LINE.

x

B

Disables wind noise reduction.

Enables wind noise reduction.

 appears on the status check screen.

b

• The setting is not effective when you set the 

INPUT1 switch to LINE.

x

x

x

You can set INPUT2 in the same way as 
INPUT1.

z

• -48dBu is set as 0dB in your camcorder.
• Set [INPUT TRIM] to [0dB] for the supplied 

microphone (ECM-XM1).

• Set [INPUT TRIM] to [+12dB] for a 

microphone with an average sensitivity, 
including the optional microphone (Sony ECM-
NV1).

• The INPUT TRIM function adjusts the input 

level from an external microphone. When using 
a highly sensitive microphone or recording loud 
sound, set this to the minus side. When using a 
less sensitive microphone or recording quiet 
sound, set it to the plus side.

• When recording loud sound, the sound may be 

distorted at either the input point or the 

recording point. If it is distorted at the input 
point, adjust the sound using the INPUT TRIM 
function. If it is distorted at the recording point, 
lower the total volume level manually.

• If you set INPUT TRIM too far to the minus 

side, the microphone volume becomes too low, 
resulting in a poor signal to noise ratio.

• Test the effect of the INPUT TRIM function 

according to the microphone used or the sound 
field of the recording site before actual 
recording.

B

Reproduces sound of CH1 and CH2 in 
respective channels.

Reproduces sound of CH1 in channels 1 
and 2.

Reproduces sound of CH2 in channels 1 
and 2.

Reproduces mixed sound of CH1 and CH2 
in channels 1 and 2.

z

• When you select [CH1,CH2] and play back a 

tape on your camcorder, sound of CH1 + CH2 
comes out of the speakers.

• When you select [CH1+CH2], the same sound is 

outputted from right and left speakers of a 
device to be connected.

You can monitor the sound dubbed from 
another device or recorded through 4-
channel microphone during playback. You 
can set how to output the sound.

B

Outputs only the sound recorded in CH1 
and CH2 during recording.

Outputs mixed sound of the sound 
recorded in CH1 and CH2 during 

,