Sony hvr-z1e-z1p Manual Do Utilizador
G:\HDR_HVR\HVR_Kaihan\2514607111\2514607121HVRZ1E\01GB04REC.fm
master:Right
Rec
o
rdin
g
HVR-Z1E/Z1P
2-514-607-12(1)
Recording
39
The audio level meter appears.
2
During recording or in the standby
mode, adjust the volume of the
microphone by turning the AUDIO
LEVEL dial.
mode, adjust the volume of the
microphone by turning the AUDIO
LEVEL dial.
Adjust the microphone level of channel 1
by turning the CH1 dial, and that of channel
2 by turning the CH2 dial.
Adjust the internal microphone volume by
turning the CH1 dial.
by turning the CH1 dial, and that of channel
2 by turning the CH2 dial.
Adjust the internal microphone volume by
turning the CH1 dial.
To restore automatic adjustment
Set the AUDIO SELECT switch of the
manually adjusted channels to AUTO.
manually adjusted channels to AUTO.
b
Note
• You cannot adjust the volume of audio input via the
AUDIO/VIDEO jack or the
HDV/DV jack.
z
Tip
• To check the audio setting information in greater
detail, press STATUS CHECK (p. 25). You can also
check the microphone volume during automatic
adjustment.
check the microphone volume during automatic
adjustment.
• When using an external microphone, set [MIC
SELECT] on the
(AUDIO SET) menu to [XLR]
(p. 66).
• To link the audio level of channel 1 and channel 2
when using external microphones, select the
(AUDIO SET) menu, [XLR SET], [XLR AGC
LINK], then [LINKED] (p. 67). Make sure that the
AUDIO SELECT switches, CH1 and CH2, are both
set to AUTO.
LINK], then [LINKED] (p. 67). Make sure that the
AUDIO SELECT switches, CH1 and CH2, are both
set to AUTO.
Connecting external audio
sources
sources
Connect an external microphone and/or
audio device to the INPUT1/INPUT2
connectors.
audio device to the INPUT1/INPUT2
connectors.
To attach an external microphone
Only a Sony microphone of 21 mm in diameter
(ECM-678) can be attached.
(ECM-678) can be attached.
1
Loosen the microphone holder screw,
and open the cover.
and open the cover.
2
Place the microphone in the microphone
holder, close the cover, and tighten the
screw.
Hook the microphone cable on the cable
holder.
holder, close the cover, and tighten the
screw.
Hook the microphone cable on the cable
holder.
b
Note
• If the microphone part of the attached external
microphone is long, it may obstruct the light of a
video light, etc. attached to the shoe adaptor.
video light, etc. attached to the shoe adaptor.
External microphone
(optional)
(optional)
Cable holder
01GB04REC.fm Page 39 Thursday, June 9, 2005 8:40 PM