Sony LBT-ZUX9 Manual Do Utilizador
55
US
Ad
di
di
ti
on
al
al
I
n
fo
rmati
o
n
The tape does not erase completely.
• The record/playback heads are
There is excessive wow or flutter, or
the sound drops out.
the sound drops out.
• The capstans or pinch rollers are dirty
Noise increases or the high
frequencies are erased.
frequencies are erased.
• The record/playback heads are
The tape does not record.
• No tape is loaded. Load a tape.
• The tab has been removed from the tape.
• The tab has been removed from the tape.
Cover the broken tab with adhesive tape
(page 58).
(page 58).
• The tape has reeled to the end.
The system cannot play back the
reverse side of the tape in Deck A or
Deck B.
reverse side of the tape in Deck A or
Deck B.
• The system only can play back front
side of the tape in Deck A and Deck B.
This is not a malfunction.
This is not a malfunction.
The system cannot record the reverse
side of the tape in Deck B.
side of the tape in Deck B.
• The system only can record front side of
the tape in Deck B. This is not a
malfunction.
malfunction.
When you press
.
or
>
, “Not in
Use” flashes in the display.
• The system does not have AMS
(Automatic Music Sensor) function.
This is not a malfunction.
This is not a malfunction.
The recorded sound has echo effect.
• Before you start recording, press
FLANGER, DELAY, CHORUS and
AQUA repeatedly to turn off the
effector mode.
AQUA repeatedly to turn off the
effector mode.
Optional components
There is no sound.
• Refer to General item “There is no
sound.” (page 49) and check the
condition of the system.
condition of the system.
• Connect the component properly
(page 47) while checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all
– if the cords are connected properly.
– if the cord plugs are firmly inserted all
the way.
• Turn on the connected component.
• Refer to the operating instructions
• Refer to the operating instructions
supplied with the connected component
and start playing.
and start playing.
If the system still does not operate
properly after performing the above
measures or other troubles not
described above occur, reset the
system as follows:
properly after performing the above
measures or other troubles not
described above occur, reset the
system as follows:
Use the buttons on the unit for the
operation.
operation.
1
Unplug the power cord.
2
Plug in the power cord again.
3
Press
"/1
to turn on the system.
4
Press
x
, ENTER and
"/1
at the
same time.
“COLD RESET” appears in the
display.
display.
The system is reset to the factory settings.
You should set the settings you made,
such as the preset stations, clock and
timer.
You should set the settings you made,
such as the preset stations, clock and
timer.