Sony pdw-f30 Manual Do Utilizador

72

File Operations in File Access Mode

  Chapt

er 5  F

ile Ope

rat

ions

a) UTF-8 file names can be up to 63 bytes in length. (Depending on the 

character type, file names (including extension) may be limited to 21 
characters.)

b) Only when the Write Inhibit tab on the disc is set to enable recording and 

“REC INH” is set to “OFF”.

The following directory operations are possible in the 
General directory.
• Directory creation (up to 64 levels, including the 

General directory)

• Deletion and renaming of directories

• The maximum number of files that can be created on one 

disc, including directories, is 5,000.

• File names and directory names can use letters, numbers, 

and symbols from the Unicode 2.0 (UTF-8) character 
set. 
However, the following control characters and 
symbols

1)

 cannot be used.

- Control characters: U+0000 to U+001F, U+007F
- Symbols: ", *, /, :, <, >, ?, \, |

1) This is supported from firmware version 1.4. However, the following 

character codes cannot be used by FAM connections. U+010000, 
U+020000, U+030000, U+040000, U+050000, U+060000, 0U+70000, 
U+080000, U+090000, U+0A0000, U+0B0000, U+0C0000, U+0D0000, 
U+0E0000, U+0F0000, U+100000

Operating system requirements for file operations by file 
access mode are as follows.
• Computer operating system: Microsoft Windows 

2000 Service Pack 4 or higher, or Microsoft 
Windows XP

Do the following on the remote computer and this unit.
• Install the FAM driver on the remote computer (see the 

next item).

• In the setup menu, set INTERFACE SELECT >i.LINK 

MODE to “FAM (PC REMOTE)” (see page 85).

To install the FAM driver
Insert the supplied CD-ROM (PDZ-1 Proxy Browsing 
Software) in the CD-ROM drive of the computer and 
execute the Setup.exe file, then follow the installation 
instructions.

Proceed as follows.

If there is a disc loaded in this unit, put the unit into the 
following state.

• Recording, playback, search and other disc 

operations: Stopped

• THUMBNAIL button (see page 13): Off
• Disc access by DELETE LAST CLIP, DELETE 

ALL CLIPS, QUICK FORMAT in the DISC menu, 
and so on: Stopped 

• MENU button: OFF
• Unsaved current clip list: Save or clear

Connect the   S400 connector on this unit to the 
i.LINK (IEEE1394) connector on the remote 
computer, using an i.LINK cable.