Sony SNC-VL10N Manual Do Utilizador

Setting the User — User Setting Page

15

Displays the date and time set on your computer.
When you want to synchronize the camera’s date and 
time with the date and time setting of the computer, 
operate as follows:
Click Time Synchronization, and “Applied, OK” 
window appears.  Click OK to change the date and time 
on SNC-VL10 Current Date&Time to the date and 
time setting of the computer.

When you want to set the camera’s date and time 
manually, operate as follows:
Type the date and time you want to set for the camera 
and click Time Synchronization.  “Applied, OK” 
window appears.  Click OK to change the date and time 
on SNC-VL10 Current Date&Time to the date and 
time you typed.

When you want to set the camera’s date and time to the 
time in the area where the camera is installed, select the 
camera location from the drop-down list.

Type the maximum number of clients (1 to 100) that can 
log in this camera at the same time.

Resets to the factory settings.
Click Factory Setting, and “All configuration 
information will be initialized as factory setting.  Are 
you sure?” appears.  Click OK to reset to the factory 
settings.

The following settings cannot be reset with this 
operation: Date and time on the System Setting page, 
and IP Address, Subnet Mask, Broadcast Address and 
Default Gateway on the Network Setting page.

Reboots the camera.
Click Reboot, and “The SNC-VL10 will be rebooted.  
Are you sure?” appears.  Click OK to reboot the camera.

If the setting page cannot be displayed after you have 
clicked Reboot, refresh the Web browser window.
The Menu page is displayed.

When you click User in the menu section, the User 
Setting page appears.
Use this page to set the user names and passwords of 
Administrator and up to five kinds of users (User 1 to 
User 5), and the access right of each user.

Type a user name up to 9 characters.

Type a password up to 9 characters.

To confirm the password, type the same characters as 
those you typed in the Password box.
If you re-type an incorrect character, “Password is 
different with Re-Typed Password” will appear when 
you click Apply later.  In this case, click OK to cancel 
the message and re-type the correct password.

Select the access right for each user from the drop-down 
list.

Allows only monitoring of the camera image on the 
viewer page, including the operations of the monitor 
image.

Allows monitoring of the camera image and alarm 
output by clicking Sensor 1 and Sensor 2 on the viewer 
page.