Sony tsl-s11000 Manual Do Utilizador
Chapter 2
Preparation
13
Interconnections
The SCSI bus allows connection of up to seven peripherals to the host
computer. Use a SCSI cable with a High-Density 68 pin connector.
computer. Use a SCSI cable with a High-Density 68 pin connector.
Precautions:
• Switch off the host computer and peripherals before connecting the SCSI
• Switch off the host computer and peripherals before connecting the SCSI
cable.
• Make sure the SCSI connectors are pressed tightly together.
• If this unit is the last (or only) device on the SCSI bus, make sure to connect
• If this unit is the last (or only) device on the SCSI bus, make sure to connect
a SCSI bus terminator to the open connector.
• The TSL-S11000 supports both single-ended and low voltage differential
SCSI configurations as set forth in the X3T10/1142D (SCSI Parallel
Interface 2) Standard. Only unshielded connectors are supported. Possible
cable and connector sources are listed below. This does not imply that these
are the only sources for SCSI accessories.
Note
When using high speed data transfer with the TSL-S11000, it is
recommended that total length of the SCSI data cable not exceed 1.5 m for
single-ended SCSI configuration. For low voltage differential SCSI
configuration, less than 12 m is recommended.
Interface 2) Standard. Only unshielded connectors are supported. Possible
cable and connector sources are listed below. This does not imply that these
are the only sources for SCSI accessories.
Note
When using high speed data transfer with the TSL-S11000, it is
recommended that total length of the SCSI data cable not exceed 1.5 m for
single-ended SCSI configuration. For low voltage differential SCSI
configuration, less than 12 m is recommended.
Cable
30 AWG Ribbon
Hitachi UL 20848 (or equivalent)
Hitachi UL 20848 (or equivalent)
Connector
AMP 1-786090-7 (or equivalent)
Interconnections
AC power
SCSI cable
Terminator