Panasonic cf-w2dwb02km Manual Do Utilizador

24

A Slide the latch (A) located at the front.
B Lift open the display.

z Do not open the display wider than necessary (135° or more), and do 

not apply excessive pressure to the LCD.  Also, do not hold the LCD 
when opening or closing the display.

Slide the power switch 

 and hold it for approximately one second until the 

power indicator 

 turns on before releasing it.

z Do not slide the power switch and hold it for more than four seconds; this 

will cause the power to be turned off forcibly.

z While booting, avoid the following until the hard disk drive indicator   has 

turned off.
• Connecting or disconnecting the AC adaptor.
• Touching the power switch.
• Performing any keyboard, touch pad, or external mouse operations.
• Closing the display.

z Do not slide the power switch repeatedly.
z Once the computer is powered off, you must wait at least ten seconds 

before powering it on again.

After confirming that the hard disk drive indicator 

 has turned off, click the 

user (user's icon).
z Input the password, then click  . Until the correct password is entered, 

the computer will not operate.
Confirm that character input is not set to “Caps Lock” or “NumLK.” 
(

z This operation may differ according to [Use the Welcome screen setting].
z When only one user has been created and no password has been set, the 

screen for selecting the user will not be displayed (automatic log-on).

Run various software applications, etc. and operate them.

z The power saving function is factory set, so if there is no input from a key, the touch 

pad or an external mouse (when one is connected) for a certain interval of time, the 
power to the LCD and hard disk may be turned off.  The LCD will resume operation 
when the touch pad or an external mouse (when one is connected) is used or a key 
is pressed.
The power to the LCD may be turned off even when an application software is 
being installed.  In this case, because it is conceivable that a selection dialog 
box will be shown, do not press the 

Space key or the Enter key to attempt to 

resume from this condition as doing so may trigger a selection, but instead, 
press a key unrelated to the direct triggering of a selection, like the 

Ctrl key.

In addition, when the computer is left alone, it automatically enters the standby 
or hibernation mode. The computer will resume by sliding the power switch. 
(

ΓChapter 2: Standby/Hibernation Functions” in onscreen Reference Manual)