Panasonic cq-4400u Manual Do Utilizador
11
TPS Operation (Tape program
Search)
Search)
Press [4 TPS] to activate the tape program search mode.
To select a desired program, press [i
i] or [j
j] corresponding
times to go backward (up to 8) or forward (up to 9).
(Rewind:)
(Fast forward:)
8
0
1
9
c
d
c
d
Ex1. To select the current program
again, press [4 TPS], and
press [i
press [i
i].
Ex2. To select the previous pro-
gram, press [4 TPS], and
press [i
press [i
i] twice.
Ex3. To select the next program,
press [4 TPS] and press [j
j].
Ex4. To select the next 3rd pro-
gram , press [4 TPS], and
press [j
press [j
j] three times.
Press [4 TPS] again to cancel.
Notes: The TPS mode may not work correctly in the following
cases. This, however, does not mean that the unit is defective.
cases. This, however, does not mean that the unit is defective.
●
There is an interval less than 4 seconds or having a high level of
noise or hum between programs.
noise or hum between programs.
●
There is particularly low-level passage during the program.
Notes:
●
To maintain your cassette player in top condition, avoid using tapes that are longer than 90
minutes (C-90).
minutes (C-90).
●
If you insert into the unit a cassette with a loose tape caused by forcing it into cassette with a
finger or the like, the cassette may not be properly reproduced. In such a case, eject the cassette,
make the tape tight, then insert it back into the deck.
finger or the like, the cassette may not be properly reproduced. In such a case, eject the cassette,
make the tape tight, then insert it back into the deck.
d
or