Panasonic CQ-CB8901U Manual Do Utilizador

Installation

Notes on discs, Maintenance, Installation

CQ-CB8901U

Notes on Discs

How to hold the disc

Do not touch the underside of the disc.

Do not scratch on the disc.

Do not bend the disc.

When not in use, keep disc in the case.

Do not use irregularly shaped discs.

Do not leave discs in the following places:

In direct sunlight

Near car heaters

Dirty, dusty and damp areas

On seats and dashboards

Disc cleaning

Use a dry, soft cloth to wipe from the center outward.

Do not attach any seals or labels to your discs.

Do not write on the disc label with a ballpoint
pen or other hard-point pens.

Printed side

<Wrong>

Do not use irregularly shaped discs.

If you use commercial CDs, they must have
either of these labels shown at right.
Some copy-protected music CDs are not
playable.

TEXT

You may have trouble playing back some CD-R/RW discs recorded on CD recorders (CD-R/RW drives), either due
to their recording characteristics or dirt, fingerprints, scratches, etc. on the disc surface.

CD-R/RW discs are less resistant to high temperatures and high humidity than ordinary music CDs. Leaving them
inside a car for extended periods may damage and make playback impossible.

Some CD-R/RWs can not be played back successfully thanks to incompatibility among writing software, a CD
recorder (CD-R/RW drive) and the discs.

This player cannot play the CD-R/RW discs if the session is not closed.

This player cannot play the CD-R/RW discs which contains other than CD-DA or MP3/WMA data (Video CD, etc.).

Be sure to observe the instructions of CD-R/RW disc for handling it.

Notes on CD/CD Media (CD-ROM, CD-R, CD-RW)

Your product is designed and manufactured to ensure the minimum of maintenance. Use a soft cloth for
routine exterior cleaning. Never use benzine, thinner, or other solvents.

Notes on

CD-Rs/RWs

Maintenance

Cleaning the

Unit

Fuse

If the fuse blows out, consult your dealer, or your nearest authorized Panasonic Servicenter.

Warning

Use fuses of the same specified rating (15 A). Using substitutes or fuses with higher ratings, or connecting the
unit directly without a fuse could cause fire or damage to the unit. If the replaced fuse fails, contact your
nearest authorized Panasonic Servicenter.

WARNING

❐

This installation information is designed for professional installers with

knowledge of automobile electrical safety systems and is not intended for non-
technical, do-it-yourself individuals. It does not contain instructions on the
electrical installation and avoidance of potential harm to air bag, anti-theft and
ABS braking or other systems necessary to install this product.
Any attempt to install this product in a motor vehicle by anyone other than a
professional installer could cause damage to the electrical safety system
and could result in serious personal injury or death.

❐

If your car is equipped with air bag and/or anti-theft systems, specific proce-

dures may be required for connection and disconnection of the battery to install
this product.
Before attempting installation of this electronic component against the man-
ufacturer's recommendation, you must contact your car dealer or manufac-
turer to determine the required procedure and strictly follow their instruc-
tions.

FAILURE TO FOLLOW THE PROCEDURE MAY RESULT IN THE UNINTENDED
DEPLOYMENT OF AIR BAGS OR ACTIVATION OF THE ANTI-THEFT SYSTEM
RESULTING IN DAMAGE TO THE VEHICLE AND PERSONAL INJURY OR
DEATH.

This product should be installed by a professional.
However, should you decide to install the product
against the manufacturer's recommendation, this
operating Instructions does not contain electrical
installation instructions. You must contact your car
dealer or manufacturer for electrical connection
instructions to avoid possible damage to your electri-
cal safety systems and resulting injury or death.
(Please refer to the “WARNING” statement above).
Your next step is to decide where to install the unit
The instructions in these pages will guide you
through the remaining steps:
¡

Identify and label the car wires.

Connect the car wires to the wires of the power
connector.

Install the unit.

Check the operation of the unit.

If you encounter problems, please consult your near-
est professional installer.

Caution: This unit operates with a 12 V DC

negative ground auto battery system only. Do

not attempt to use it in any other system. Doing

so could cause serious damage.

Before you begin installation, look for the following
items which are packed with your unit.

Installation Hardware … Needed for installation.

Over

view