Panasonic cq-va7300n Manual Do Utilizador
67
65
E
N
N
G
L
I
S
H
H
66
E
N
N
G
L
I
S
H
H
CQ-VA7300N
CQ-VA7300N
66
Error Display Messages
- E3 -
NO DISC
Display
Cause / Step
- E1 -
- E2 -
■
CD Changer
NO MAGAZINE
Notes:
¡
¡
There may be cases when the disc numbers affected by an error are displayed before E1 and E2.
¡
Displays and the steps to be taken for errors vary in part from changer to changer. For details, refer to the Operating
Instructions for the changer used.
Instructions for the changer used.
Troubleshooting
(continued)
Trouble
Cause / Step
■
Car Navigation, VCR, Camcorder, Rear View Camera, Rear Monitor
The picture from a car
navigation system is
not displayed.
navigation system is
not displayed.
The connection of a car navigation system is not correct.
a
Connect it correctly.
Input setting of a car navigation system is not correct.
a
Make the input setting correct.
The picture from a VCR or a
camcorder is not displayed.
camcorder is not displayed.
A VCR or Camcorder is not connected correctly.
a
Connect a VCR or Camcorder correctly.
The picture from a rear
view camera is not dis-
played.
view camera is not dis-
played.
A VCR or Camcorder is not connected correctly.
a
Connect a VCR or Camcorder correctly.
Input setting of a camera is not correct.
a
Make the input setting correct.
Trouble
Cause / Step
■
Display Settings
The brightness of the
screen is not stable.
screen is not stable.
“AUTO” dimmer is selected.
a
Select one of the dimmer levels from among 1 to 4 to make the dimmer
adjustment become free from light intensity.
adjustment become free from light intensity.
Red, blue, or green
spots appears.
spots appears.
This is a characteristic of liquid crystal panels and is not defective.
The picture is dark.
The picture is whitish.
Something is wrong
with the picture. The
picture is light in color.
The picture is whitish.
Something is wrong
with the picture. The
picture is light in color.
The screen is not adjusted properly.
a
Make every adjustment of the screen.
Disc is dirty, or is upside down.
a
Check disc.
Disc has scratches.
a
Check disc.
No operation by some cause.
a
Eject the magazine. If failure persists, press the reset switch on the CD
changer. If normal operation is not restored, call the store where you pur-
chased the unit or the nearest Panasonic Service Center.
changer. If normal operation is not restored, call the store where you pur-
chased the unit or the nearest Panasonic Service Center.
No disc is in the magazine.
a
Insert discs into the magazine.
No magazine is in the changer.
a
Load the changer with CD-loaded magazine.
Trouble
Cause / Step
■
Radio
Too much noise in FM
stereo and monaural
(AM) broadcasts.
stereo and monaural
(AM) broadcasts.
Station is too far, or signals are too weak.
a
Select other stations of higher signal level.
The radio antenna is not extended enough.
a
Extend the radio antenna enough.
The motor antenna relay control lead is not connected correctly.
a
If there is a motor antenna in the car, connect the motor antenna relay
control lead to the motor antenna lead that is installed in the car correctly.
control lead to the motor antenna lead that is installed in the car correctly.
The ground connection of the radio antenna is not secure enough.
a
Check the ground connection of the mounted base part of the antenna,
and tighten up the screw.
and tighten up the screw.
Preset station is reset.
Battery cable is not correctly connected.
a
Connect the battery cable to the terminal that is always active.