Panasonic dmr-e55ebl Manual Do Utilizador
STEP
1
Connection
- 2 -
≥
When there is no 21-pin Scart terminal on the television (
➡
page 3)
≥
Change the “AV2 Input” setting to match the output from a satellite receiver and set the “AV2 Connection” setting to “Normal” in the SETUP
menu (
➡
page 41 of Operating Instructions) after tuning is completed (
➡
page 5, 6).
∫
To view satellite programmes
Press [INPUT SELECT] to select the input channel “A2” for the satellite receiver or put this unit in standby mode.
To record programmes from satellite receiver using “Sky Personal Planner” function
➡
page 23 of Operating Instructions
∫
RGB
This refers to the three primary colours of light, red (R), green (G), and blue (B) and also the method of producing video that uses them. By
dividing the video signal into the three colours for transmission, noise is reduced for even higher quality images.
dividing the video signal into the three colours for transmission, noise is reduced for even higher quality images.
To record programmes from satellite receiver by RGB signals
➡
page 23 of Operating Instructions
Connecting a television with 21-pin Scart terminal and Satellite receiver
R - AUDIO - L
VIDEO
P
R
S-VIDEO
R - AUDIO - L
VIDEO S-VIDEO
OPTICAL
OUT
AV
4
4
I
N
RF IN
RF OUT
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
COMPONENT
VIDEO OUT
(NTSC:480P/480I,
PAL:576P/576I)
P
B
Y
AV1 (TV)
AV2 (DECODER/EXT)
AC IN
AV IN
VHF/UHF
RF IN
DVD/VCR
2
3
1
1
4
4
Fully wired 21-pin
Scart lead
RF
coaxial lead
AC mains lead
Connect only after all other
connections are complete.
Connect only after all other
connections are complete.
Cooling fan
Fully wired 21-pin
Scart lead
Scart lead
Satellite receiver’s rear panel
To household mains socket
(AC 220–240 V, 50 Hz)
Television’s
rear panel
rear panel
Aerial
lead
lead
To the
aerial
aerial
AV1 terminal
If your television is equipped with RGB input capability, by
connecting with a fully wired 21-pin Scart lead you can see
video using RGB output on this unit (
If your television is equipped with RGB input capability, by
connecting with a fully wired 21-pin Scart lead you can see
video using RGB output on this unit (
➡
below).
To output in RGB select “RGB (without component)” from “AV1
Output” in the SETUP menu (
Output” in the SETUP menu (
➡
page 41 of Operating
Instructions).
This unit’s
rear panel
rear panel
indicates included accessories.
indicates accessories not included.
are required connections. Connect in the numbered order.
BE SURE TO READ THE CAUTION FOR
THE AC MAINS LEAD ON PAGE 2 IN
THE OPERATING INSTRUCTIONS
BEFORE CONNECTION.
THE AC MAINS LEAD ON PAGE 2 IN
THE OPERATING INSTRUCTIONS
BEFORE CONNECTION.
Page1-3,6.fm 2 ページ 2004年2月10日 火曜日 午後3時19分