Panasonic ty-42tm6ma Manual Do Utilizador
4
English
Antenna Connection
VHF Antenna UHF Antenna
75
Ω
Coaxial
Cable
Cable
Ferrite core
(included)
(included)
Ferrite core
(included)
F-type antenna
adapter (included)
adapter (included)
Note
• To obtain optimum quality picture and sound,
• To obtain optimum quality picture and sound,
an Antenna, the correct cable (75
Ω coaxial)
and the correct terminating plug are required.
• If a communal Antenna system is used, you
may require the correct connection cable
and plug between the wall Antenna socket
and your television receiver.
and plug between the wall Antenna socket
and your television receiver.
• Your local television service center or dealer
may be able to assist you in obtaining the
correct Antenna system for your particular
area and the accessories required.
correct Antenna system for your particular
area and the accessories required.
• Any matters regarding Antenna installation,
u p g r a d i n g o f e x i s t i n g s y s t e m s o r
accessories required, and the costs
incurred, are your responsibility.
accessories required, and the costs
incurred, are your responsibility.
For proper reception of VHF/UHF channels, an external antenna is required. For best reception, an outdoor antenna is
recommended. The antenna mode must be set to “TV” (see page 11, SET UP menu-MODE).
recommended. The antenna mode must be set to “TV” (see page 11, SET UP menu-MODE).
Connection
1.Remove the
slot cover.
2.Insert the terminal board
until it is firmly plugged
into the connector.
Tighten screws in the
order
into the connector.
Tighten screws in the
order
1
-
4
.
3.Affix the terminal
function label
(included).
(included).
To install
75
Ω VHF/UHF
Remove the slot cover. Grip the
handle of the terminal board, and
slowly pull out in the direction of
the arrow.
handle of the terminal board, and
slowly pull out in the direction of
the arrow.
To remove
• Make sure that the Board does not ride on the two lower claws.
• Be sure to fasten all screws tightly.
• Have the customer keep the removed Terminal Board for future servicing needs.
• Be sure to fasten all screws tightly.
• Have the customer keep the removed Terminal Board for future servicing needs.
Mixer
Securing screw
Compatible slot Nos. are SLOT1 and SLOT2.
SLOT3 is not
compatible.
compatible.
Precautions
• Before installation
• Before installation
Turn the power switch off and disconnect the plug of the display. Disconnect all the plugs connected to the display.
• Before removing, turn the power off with the tuner board’s remote control and then turn the main power off.
• When installing or removing the terminal board, exercise care to avoid injury.
• When installing or removing the terminal board, exercise care to avoid injury.
There may be some sharp-pointed solder joints on the rear side of the board that could cause unexpected injury.
• When installing the board, fully insert the Board into the slot horizontally until it is firmly plugged into the
connector.
Note that incomplete insertion may damage the internal components.
Note that incomplete insertion may damage the internal components.
Foam mat or thick soft cloth
SERIAL
PC IN
AUDIO
SERIAL
PC IN
AUDIO
2 slots model
3 slots model
• Terminal function label
SLOT1
SLOT2
SLOT3
SLOT2
SLOT1
Installation