JVC dr-m7s Manual Do Utilizador
Filename [DR-M7EK_06Name.fm]
Masterpage:Left0
28
Page 28
April 2, 2004 3:28 pm
SAT CONTROL SET
Satellite Receiver
Control Setting
The following procedure is required if you receive
satellite channels through a satellite receiver.
Approximately 20 seconds before the VIDEO Plus+ timer
programming (
satellite channels through a satellite receiver.
Approximately 20 seconds before the VIDEO Plus+ timer
programming (
墌
pg. 56) or Manual Timer programming
(
墌
pg. 58) starts, the unit sets its input mode to “L-2” and
automatically switches the satellite receiver’s channels
using an optional Satellite Controller.
using an optional Satellite Controller.
Installing Satellite Controller
A
Install a Satellite Controller.
Place a Satellite Controller so that the path between its
transmitter and the satellite receiver’s remote sensor is
unobstructed.
transmitter and the satellite receiver’s remote sensor is
unobstructed.
B
Attach the Satellite Controller.
Fix securely using the adhesive strip attached on the back
of the Satellite Controller.
of the Satellite Controller.
C
Make connections.
Be sure to connect the unit’s L-2 IN/DECODER connector
to the satellite receiver’s 21-pin SCART connector.
to the satellite receiver’s 21-pin SCART connector.
NOTE:
When connecting your satellite receiver, refer to its instruction
manual.
manual.
D
Connect the Satellite Controller to unit.
Connect the Satellite Controller to the SAT CONTROL
connector on the rear panel.
connector on the rear panel.
Satellite receiver
Satellite Controller
(not provided)
(suggested locations)
(not provided)
(suggested locations)
Transmitter
21-pin SCART cable
(provided)
(provided)
SAT CONTROL
L-2 IN/DECODER
Your unit
Satellite Controller
(not provided)
(not provided)
Satellite receiver
Back of unit
DR-M7EK_06Name.fm Page 28 Friday, April 2, 2004 3:28 PM