JVC GR-D796U Manual Do Utilizador

MasterPage: Left

The camcorder needs to be powered up to 
load or eject a cassette. 

Slide and hold OPEN/EJECT in the 

direction of the arrow, then pull the cassette 
holder cover open until it locks. The cassette 
holder opens automatically.

● Do not touch internal components.

Insert or remove a tape and press “PUSH” 

to close the cassette holder. 

● Be sure to press only the section labeled 

“PUSH” to close the cassette holder; touching 
other parts may cause your finger to get caught 
in the cassette holder, resulting in injury or 
product damage.

● Once the cassette holder is closed, it recedes 

automatically. Wait until it recedes completely 
before closing the cassette holder cover.

● When the battery pack’s charge is low, you may 

not be able to close the cassette holder cover. 
Do not apply force. Replace the battery pack 
with a fully charged one or use AC power before 
continuing.

Close the cassette holder cover firmly until 

it locks into place.

● If you wait a few seconds and the cassette 

holder does not open, close the cassette holder 
cover and try again. If the cassette holder still 
does not open, turn the camcorder off then on 
again.

● If the tape does not load properly, open the 

cassette holder cover fully and remove the 
cassette. A few minutes later, insert it again.

● When the camcorder is suddenly moved from a 

cold place to a warm environment, wait a short 
time before opening the cassette holder cover. 

• Appears if a tape is loaded while the Power 

Switch is set to “REC”.

• Blinks when no tape is loaded.

Appears if a tape is not loaded when the 
Recording Start/Stop Button or SNAPSHOT 
Button is pressed while the Power Switch is set to 
“REC” and the VIDEO/MEMORY Switch is set to 
“VIDEO”.

Appears when the erase protection tab is set to 
“SAVE” while the Power Switch is set to “REC” 
and the VIDEO/MEMORY Switch is set to 
“VIDEO”. (

GR-D796US_EN.book  Page 16  Friday, December 15, 2006  11:31 AM